Ayan Bakdauletuly

Mr. Ayan Bakdauletuly

orcid

Research Focus & Metrics

Representative Publications

View All Publications
26 March 2024 in Bulletin of Dulaty University
Verified
Journal Article
Closed access
ABAyan Bakdauletuly
Ayan Bakdauletuly
TMT.T. Mashan
T.T. Mashan

26 October 2026 in Recycling
Verified
Journal Article
Open access
PDF file
Eldar KopishevEldar Kopishev
Eldar Kopishev
ABAyan Bakdauletuly
Ayan Bakdauletuly
MDMarat Duisembiyev
Marat Duisembiyev
KMKamola Alimdjanovna Mannapova
Kamola Alimdjanovna Mannapova
SMShakhnoza Abduvaliyevna Makhmudova
Shakhnoza Abduvaliyevna Makhmudova
Platinum group metals (PGMs) are key components of automotive emission-control catalysts, and spent automotive catalysts (SACs) are their main secondary source. This paper reviews hydrometallurgical, pyrometallurgical, magnetic-separation, biometallurgical, and ionic-liquid/deep-eutectic-solvent (IL/DES) routes and compares them for recovery, selectivity, energy demand, reagent hazard, technology readiness, and scalability, using values re-checked against accessible primary sources. Smelting with Cu- or Fe-based collectors is the only fully industrial route and gives the highest reported recoveries (≈90–99% for Pt and Pd and ≈85–98% for Rh). Hydrometallurgical leaching operates at lower temperature and separates the individual metals but relies on corrosive reagents and dissolves rhodium slowly. Magnetic-separation methods are pre-concentration steps, and biometallurgical and IL/DES routes remain at laboratory scale; their environmental performance has not yet been established by life-cycle assessment. A paired comparison of Rh with Pt and Pd shows that leaching at ≤90 °C typically extracts about 10–60 percentage points less Rh than the best-recovered companion metal, whereas gaps of about 10 points or less are reported for most smelting studies and for some intensified chloride leaching (≥150 °C, alkali calcination, or iron alloying). Integrated flowsheets coupling pretreatment with selective refining remain to be demonstrated at scale and need consistent techno-economic and life-cycle assessment.