This paper presents the implementation of a modern approach for automatic measurement, data acquisition, and processing using custom-developed software based on the ARDUINO version: 2.3.6 platform. State-of-the-art sensing elements are employed for enhanced precision and reliability. The obtained results are graphically visualized for comprehensive analysis. The ARDUINO microcontroller and its associated open-source programming environment are primarily designed for general-purpose users rather than specialized industrial applications. The study focuses on the experimental investigation of the characteristics of a Peltier element. The interdependence between current, voltage, internal resistance, and temperature differential is examined in detail. The findings concerning efficiency analysis are intended to support students across various engineering disciplines during their educational process.
17 September 2026 in Proceedings of the International Conference on Secure Systems Design and Technology Development
The present study investigates the impact of filament colour and specimen thickness on overall light transmittance in fused deposition modelling printed transparent PETG. Flat specimens were prepared in six transparent colour variants (transparent, blue, neon green, orange, red, and yellow) and in thicknesses ranging from 1.0 to 3.5 mm. The measurements were conducted within a custom-built enclosed laboratory stand, thereby ensuring the elimination of ambient light interference. In order to verify the result stability, the transmitted light was measured at four nominal source power levels (200, 2600, 6600, and 10600 lx) and evaluated as normalized transmittance. For all of the materials that were analysed, there was a decrease in transmittance as specimen thickness increased. Transparent PETG demonstrated the highest transmittance from 1.0 to 2.5 mm, while yellow PETG exhibited the highest values at 3.0 and 3.5 mm. In the present study, the lowest transmittance was exhibited by blue PETG at all thickness levels, with the approach of complete attenuation being observed in thicker specimens. Neon green exhibited an intermediate level of transmission, while orange and red demonstrated comparatively reduced transmission following a notable decline between 1.0 and 1.5 mm. The normalized values were found to be consistent across the higher source power settings, thereby supporting the reliability of the measured attenuation trends. The findings of this study demonstrate that transparent tinted PETG filaments cannot be regarded as optically equivalent, and that specimen thickness is a significant factor in determining attenuation in printed components.
The article presents a study of the overall brightness of semi-transparent materials used in additive manufacturing. Components with varying thicknesses and diverse types of finished surfaces were manufactured and evaluated under various lighting conditions. The test components were fabricated from a transparent PETG (polyethylene terephthalate) material. The printing parameters were selected based on a series of experiments conducted on this type of material. The measurements were conducted on a specially designed and manufactured stand for measuring overall light transmittance. The classical method for evaluating the results according to the normal distribution law was applied. The findings of the studies demonstrate that transmittance is predominantly contingent on the thickness of the component, as opposed to the illuminance or the nature of the surface. The discrepancy in transmittance between thicknesses of 1 and 1.5 mm for all illuminance levels is approximately 12%. As the thickness increases, the discrepancy in transmittance decreases, reaching approximately 1.5% for samples with thicknesses ranging from 2 to 3.5 mm. The light intensity exhibited a negligible effect on transmittance, with an approximate measurement of 1.5%.