Textured surfaces are the subject of a great deal of research work in tribology, which mainly involves numerical studies of lubricated contacts. A variety of shapes and arrangements of textures can be found, these being as numerous as the different authors. Depending on the configuration, it has been shown that the presence of the texture can provide better lubrication efficiency through both a reduction of friction and an increase in load-carrying capacity. However, improving bearing performance implies a specific geometrical configuration for given operating conditions. The improvement in lubricated contact performance by texturing the active surface has been demonstrated using experimental studies concerning, for example, pin-on-disk, mechanical seal, camshaft, journal bearing, thrust bearing, and piston ring set-ups. The objective of the present experimental analysis is to provide, using local measurements, a better understanding of the influence of surface texturing on the steady-state behavior of thrust bearings. To achieve this goal, the experimental device is equipped with 80 sensors such as thermocouples and pressure transducers which allowed a proper assessment of the phenomenology at the film/pad interface. The tests are conducted on five hydrodynamic thrust bearings, among which four are textured. Results show that, for the studied configurations, the textured thrust bearings can help to reduce friction up to 30% at low loads while for heavy loads, their performance is equivalent or even lower than that of an untextured planar bearing.

Aerostatic bearings were proven to be an optimal choice in situations where low friction, cleanliness, and high motion accuracy are required. Their functionality relies heavily on flow restrictors, which are responsible for regulating and controlling the supply flow, and consequently, the thickness and stiffness of the fluid film. A diverse range of restrictors with varying characteristics is used, among which are the porous restrictors. The current work introduces a novel solution involving a porous, highly compressible restrictor, whose element of novelty compared to its predecessors consists of its variable thickness and corresponding permeability, regulated by the load on the bearing. The gas is supplied through an annular, elastic, deformable, porous disc, which is compressed by a metal plate, subjected to compression by the recess pressure on one side and by the supply pressure on the other side. One or more springs are used in parallel with the porous disc to obtain the optimum elastic response. The objective of this study is to evaluate the performance characteristics and compare them to a conventional restrictor. A parametric analysis is performed to define the size and properties of the porous restrictor.