This study investigates the hypothesis that mineral fillers with distinct surface characteristics, mineralogical compositions, and morphologies exhibit different reinforcement mechanisms in asphalt mastics. Shale and pumice were evaluated as alternative mineral fillers and compared with conventional granite and limestone at 20% and 30% filler-to-asphalt (F/A) ratios by volume. Filler characterization included X-ray diffraction (XRD) analysis, scanning electron microscopy (SEM), specific surface area (SSA), and hydrophilicity coefficient (HC) measurements. Rheological characterization was performed using dynamic shear rheometer, including temperature sweep, frequency sweep master curves, multiple stress creep recovery (MSCR), linear amplitude sweep (LAS), and Glover–Rowe (G–R) analyses. Pumice, dominated by amorphous volcanic glass with the highest SSA (59.18 m²/g), exhibited rutting-dominant modification with the highest complex modulus enhancement (7.3–9.4 times at 30% F/A) and lowest non-recoverable creep compliance. Shale, composed primarily of quartz and kaolinite with layered morphology and moderate SSA (43.00 m²/g), demonstrated balanced rheological response and achieved the longest fatigue life (Nf,5% = 45,200 cycles at 20% F/A). These findings demonstrate that filler-specific reinforcement mechanisms are governed by mineralogical composition and morphology, supporting performance-based filler selection tailored to climatic and loading conditions.
This research examines road users' willingness to pay for enhanced active mobility infrastructure at King Mongkut's Institute of Technology Ladkrabang (KMITL), a suburban university campus in Bangkok, Thailand. The study addresses the need for sustainable transportation solutions in middle-income urban environments by analyzing factors that influence walking and cycling adoption among university community members. The research employed a comprehensive mixed-methods framework combining qualitative SWOT analysis, a stated preference survey of 400 participants, and binary logistic regression modeling. The analysis revealed that specific infrastructure improvements significantly increase the likelihood of active mobility adoption. Rest areas demonstrated the strongest positive association (OR=1.820, p=0.034), followed by CCTV security systems (OR=1.726, p=0.060), protective barriers separating pedestrians and cyclists from motorcycles (OR=1.608, p=0.086), and improved public transport connectivity (OR=2.192, p=0.005). Demographic analysis uncovered notable resistance patterns, with male participants (OR=0.512, p=0.096) and higher-income individuals (OR=0.114, p=0.004) showing reduced willingness to transition from motorized transportation. These findings reflect broader cultural preferences and socioeconomic factors that influence mobility choices in the Thai context. Using the Contingent Valuation Method, the study quantified potential behavioral changes, projecting an 8-16 minute daily increase in active mobility engagement. This enhancement would generate measurable health benefits for individuals and environmental improvements for the broader community. The research contributes valuable insights to the limited body of active mobility literature from Southeast Asian suburban contexts, where car and motorcycle dependency remains dominant. The findings emphasize that safety infrastructure and seamless connectivity are fundamental prerequisites for successful active mobility programs. The study's methodological approach, combining economic valuation through contingent valuation with statistical modeling via logistic regression, provides a replicable framework for similar investigations.
This study investigates the decoupling between bulk chemical composition and high-temperature viscoelastic recovery in rejuvenated asphalt binders. A pressurized aging vessel (PAV)-aged binder (AC60/70) was rejuvenated using pyrolytic bio-oils from sugarcane bagasse (SBO) and rice straw (RSO) at 5–20 wt% dosages. SARA fractionation, colloidal instability index (Ic), penetration, and multiple stress creep recovery (MSCR) testing at 0.1 and 3.2 kPa were conducted before and after a rolling thin film oven (RTFO) aging. Both bio-oils restored SARA fractions to nearly identical levels (Ic = 0.541–0.572), yet penetration diverged substantially (79 vs. 36 dmm at 20% for SBO and RSO, respectively). After RTFO aging, MSCR responses converged across all formulations regardless of pre-aging differences, yielding identical an Equivalent Single Axle Load (ESAL) classification. This convergence is attributed to selective volatilization of low-molecular-weight bio-oil components during thermal conditioning, consistent with findings from a companion rheological–fatigue study. The results reveal a fundamental decoupling: bulk chemical indices, while useful for compositional assessment, do not correspond to stress-dependent viscoelastic recovery mechanisms governing rutting resistance. Performance-based rheological testing is therefore essential for reliable evaluation of rejuvenated binders under field-relevant conditions.
This research examines road users’ willingness to pay for enhanced active mobility infrastructure at King Mongkut’s Institute of Technology Ladkrabang (KMITL), a suburban university campus in Bangkok, Thailand. The study addresses the need for sustainable transportation solutions in middle-income urban environments by analyzing factors that influence walking and cycling adoption among university community members. The research employed a comprehensive mixed-methods framework combining qualitative SWOT analysis, a stated preference survey of 400 participants, and regularized logistic regression modeling with cross-validation. The analysis revealed that specific infrastructure improvements significantly increase the likelihood of active mobility adoption. Rest areas demonstrated the strongest positive association (OR = 2.15, 95% CI: 1.08–4.27, p = 0.029), followed by CCTV security systems (OR = 1.89, 95% CI: 0.98–3.65, p = 0.047), and improved public transport connectivity (OR = 2.84, 95% CI: 1.42–5.68, p = 0.003). Demographic analysis uncovered notable resistance patterns, with male participants (OR = 0.48, 95% CI: 0.26–0.89, p = 0.020) and higher-income individuals showing reduced willingness to transition from motorized transportation. Using the Contingent Valuation Method with proper bias mitigation strategies, the study quantified potential behavioral changes, projecting a 12–18 min daily increase in active mobility engagement. This enhancement would generate measurable health benefits valued at 2840–4260 THB per person annually using WHO-HEAT methodology. The research contributes valuable insights to the limited body of active mobility literature from Southeast Asian suburban contexts, providing a replicable framework for similar investigations.