Ming Yang

Dr. Ming Yang


Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 May 2024 in Buildings
Verified
Journal Article
Open access
PDF file
MYMing Yang
Ming Yang
RWRongxing Wu
Rongxing Wu
CTChenxi Tong
Chenxi Tong
JCJianwei Chen
Jianwei Chen
BTBing Tang
Bing Tang
This paper proposed a new method for modelling joints, using anisotropic plate elements and elastic bar elements to address the issue that joints between panels are usually disregarded in numerical modelling. For small-scale deep excavations, which are frequently performed in the construction of various working shafts but have not been sufficiently studied, two numerical models were developed, using the No.1 Shaft of Tongtu Road Utility Tunnel in Ningbo, China, as a research object. One model considered the joints between the panels as proposed, while the other disregarded the joints as conventional. In comparison to the conventional method, the proposed method was validated due to yielding wall displacements that closely matched the results of the field monitoring, with a notable reduction in the error observed in the calculated displacements for the short side of the excavation. Furthermore, 34 numerical models were developed in order to investigate the influence of excavation length, depth, and diaphragm wall thickness on the relative differences between the calculated displacements obtained by the two models. The results of this study can provide references for the development of finite element models for designing small-scale deep excavation.

15 August 2025 in Buildings
Verified
Journal Article
Open access
PDF file
MYMing Yang
Ming Yang
CTChenxi Tong
Chenxi Tong
RWRongxing Wu
Rongxing Wu
GWGaoke Wang
Gaoke Wang
STShenglei Tong
Shenglei Tong
Cross-plate joints between panels are commonly used in diaphragm wall construction to ensure structural integrity. However, research on the mechanical behaviour of these joints remains limited, and they are often disregarded in numerical modelling due to their complexity. This paper fabricated two types of specimens with cross-plate joints, which were subsequently employed in bending and shear tests, respectively. The load–displacement curves and the joint openings were experimentally measured. It was found that the load–displacement curves exhibited approximately four linear stages in the bending tests and two in the shear tests. Based on the test results, a multi-linear spring model was proposed to simplify the mechanical behaviour of the joints, and the stiffness of each linear stage was determined through back-analysis of the tested data. The calculated load–displacement curves ultimately agreed well with those obtained from the tests, with average errors of 3.6% in the bending test and 2.6% in the shear test. The proposed model was then applied to a devised case study, thereby demonstrating its capacity to capture joint opening phenomena and revealing the spatial variability of joint opening within the excavation depth. Compared with conventional 2D and 3D models, the proposed model yields displacement results that better reflect the actual deformation of the diaphragm wall. Furthermore, the precise modelling calculation for joints, which is time-consuming, is also avoided, and the calculation time of the proposed model is only 1.52 times that of the conventional 3D model.