In this study, an improved discrete element model (DEM) is developed to understand the defect effect in ceramic cracking process. First, model parameters based on the linear parallel bonding model are calibrated using microcell deformation experiments and orthogonal experimental design methods. Then, the uniaxial compression of ceramics with different crack lengths and inclination angles are simulated. The crack initiation and propagation processes are illustrated with displacement and stress fields. The results show the predicted crack patterns are qualitatively in agreement with experimental observations. There are two stages of crack propagation with increasing uniaxial compressive load, i.e., primary and secondary cracks. In addition, the inclination and crack length of the defects have a great influence on the mode of crack initiation and propagation, and the first crack is more likely to initiate and extend for the defects with larger crack length and smaller inclination angle.
5 January 2023 in Computational Particle Mechanics
Delamination is a common failure mode in thermal barrier coatings (TBCs). In this work, we present an improved discrete element (DE) model to simulate the coating delamination behaviors during micro-indentation tests to better understand the failure mechanisms. In the DE model, the linear parallel bond model is first calibrated with the experimental properties from the literature. Then, both the 2D Vickers and Rockwell micro-indentation tests were simulated with layered coating microstructures. The model results reveal that the coating interface delimitation has two distinctive stages, i.e., crack initiation and propagation. Additionally, TBC systems with a thicker top are more susceptible to delamination due to less strain compliance.
The selection of internal fixation as the primary fixation modality for the patient is one of the challenges for the surgeon treating the patient in question. A model of the lateral tibial plateau fracture was established. Three different configurations of internal fixators namely L bone plate, T bone plate, and screw-washer were analyzed. Three stages after surgery were simulated to assess the displacement of bone plates, screws, washers, and the stress shielding ratio in the fracture area. At three stages after surgery, the T bone plate showed better stability for patients during rehabilitation compared with the remaining two schemes, and the screw-washer scheme was the least stable due to the larger internal fixation displacement and stress shielding ratio in the fracture area. In contrast, the L bone plate scheme showed better stability in the early stages after surgery but was second only to the screw-washer scheme in the middle and late stages after surgery. The T bone plate showed better stability and became a new selection for surgeons to treat related patients. At three stages after surgery, the T bone plate has better biomechanical stability compared to the L bone plate and screw-washer schemes.
15 July 2024 in Physical and Engineering Sciences in Medicine