Krzysztof Sołtys

Mr. Krzysztof Sołtys

orcid

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 September 2025 in Energies
Verified
Journal Article
Open access
PDF file
KSKrzysztof Sołtys
Krzysztof Sołtys
Krzysztof KluszczyńskiKrzysztof Kluszczyński
Krzysztof Kluszczyński
To explore possible design solutions for induction motors, we designed and tested a three-phase small-power induction motor with a can-type rotor and a stationary internal ferromagnetic core, a design not previously described in the technical literature. This three-phase motor combines certain features of a reliable solid-rotor motor, a two-rotor layer motor, and a motor in which the rotating thin aluminium layer is separated from the stationary inner ferromagnetic core. The motor prototype was based on a mass-produced, small-power, three-phase squirrel-cage motor. Its operating properties and characteristics were tested, highlighting its potential application as a special-purpose drive or a very interesting case for teaching purposes in laboratories of electrical machines. Measurements confirmed theoretical predictions and enabled the formation of a motor equivalent circuit with shunt and series branch parameters, among which magnetization reactance and rotor resistance varied with rotational speed. The main advantages of the motor are its simple rotor construction, low rotational speed, low-rotor inertia and good dynamics, as well as reliable operation across the entire range of useful torque from no-load to short-circuit conditions, without the risk of overheating.

26 June 2023
Verified
Conference Paper
Closed access
KSKrzysztof Sołtys
Krzysztof Sołtys
Krzysztof KluszczyńskiKrzysztof Kluszczyński
Krzysztof Kluszczyński
BPBartłomiej Pniowski
Bartłomiej Pniowski
Design and construction of a 3DoF reluctance motor with an ultra-light steel wool runner using 3D printing technology is presented. The motor was made in 3D printing technology. Experimental studies were carried out, confirming the possibility of performing a wide range of different “segmental”, “diagonal” and “complex closed” trajectories in the cubic-shaped workspace.