Inorganic particles are effective photocatalysts for the liquid-state production of organic precursors and monomers at ambient conditions. However, poor colloidal stability of inorganic micro- and nanoparticles in low-polarity solvents limits their utilization as heterogeneous catalysts and coating them with surfactants drastically reduces their catalytic activity. Here we show that effective photo-oxidation of liquid cyclohexane (CH) is possible using spiky particles from metal oxides with hierarchical structure combining micro- and nanoscale structural features engineered for enhanced dispersibility in CH. Nanoscale ZnO spikes are assembled radially on α-Fe2O3 microcube cores to produce complex ‘hedgehog’ particles (HPs). The ‘halo’ of stiff spikes reduces van der Waals attraction, preventing aggregation of the catalytic particles. Photocatalysis in Pickering emulsions formed by HPs with hydrogen peroxide provides a viable pathway to energy-efficient alkane oxidation in the liquid state. Additionally, HPs enable a direct chemical pathway from alkanes to epoxides at ambient conditions, specifically to cyclohexene oxide, indicating that the structure of HPs has a direct effect on the recombination of ion-radicals during the hydrocarbon oxidation. These findings demonstrate the potential of inorganic photocatalysts with complex architecture for ‘green’ catalysis.
Measurements of ambient ethane concentrations at a regional air quality monitor in the Eagle Ford oil and gas production region are compared to concentrations predicted using site-level hydrocarbon emission inventories coupled with a Gaussian puff dispersion model (CALPUFF). To account for more than half of mean concentrations due to routine emissions, sites at distances 20–50 km from the receptor site were included in the simulations. Nearly all of the highest observed concentrations were observed at night. For each night in the simulation, the location and magnitude of the maximum predicted concentration and maximum observed concentration were compared, and approximately two-thirds of the highest observed nighttime maximum concentrations were accounted for by routine emissions. In contrast, approximately a third of the highest daytime maxima could be accounted for by routine emissions. Most of the large observed maxima that are attributable to routine emissions are predicted to be caused by sources that were within 10 km of the receptor site, but sources up to 20 or more kilometers from the receptor also contributed to the predicted concentrations. A case study is provided demonstrating the potential of coupling site-level inventories of routine emissions with dispersion modeling for attributing sources of elevated hydrocarbon concentrations.
The performance of four widely used dispersion models (AERMOD, a single-equation Gaussian formulation, and two versions of CALPUFF) for predicting ambient hydrocarbon concentrations at a regional air quality monitor in the Eagle Ford Shale oil and gas production region was assessed. Model performance was found to vary considerably based on the performance objective, meteorological conditions, and temporal resolution. Among the models evaluated in this work, the methods used to estimate the dispersion coefficients and whether the model was plume- or puff-based strongly influenced model performance. Uncertainties in meteorological and emissions inputs also played an important role in model performance, but the significance of their impact varied depending on the performance objective. Techniques to identify and address model uncertainties and for selecting the best performing model for a given application are suggested.
Temporal variability in emissions from oil and gas supply chains depends on the spatial scale at which emissions are aggregated. This work demonstrates a framework for simulating temporally and spatially resolved emission inventories that can be broadly applied in oil and gas production regions. Emissions of methane, ethane, volatile organic compounds (VOCs), and nitrogen oxides (NOxs) from oil and gas facilities in the Marcellus production region were estimated at a one-hour time resolution for the calendar year 2023 and were aggregated at the grid cell (4 km by 4 km), county, and basin level. Maximum to average emission rate ratios decreased as the scale of spatial aggregation increased and differed by pollutant. At the grid cell level, ratios of maximum to average emission rates exceeded 100 in some grid cells for VOCs. In contrast, basin level maximum to average ratios for NOx emission rates were less than 1.1. The sources driving temporal variability in hydrocarbon emissions were well completions and liquid unloadings, while the sources driving temporal variability in NOx emissions were preproduction activities such as drilling and hydraulic fracturing. Temporally and spatially resolved inventories can inform pollutant- and region-specific measurement campaigns and mitigation strategies. Reconciliation between inventories and observations must consider event frequency, duration, and persistence, along with the spatial scale and timing of measurements.
Temporal variability in emissions from oil and gas supply chains depends on the spatial scale at which emissions are aggregated. Emissions of methane, ethane, volatile organic compounds (VOCs) and nitrogen oxides (NOx) from oil and gas facilities in the Marcellus production region were estimated at a one-hour time resolution for calendar year 2023. Emissions from more than 200,000 well sites were included in the analyses and hourly emissions were aggregated at the grid cell (4 km by 4 km), county and basin level. Ratios of maximum to annual average hourly predicted emission rates were calculated at the grid cell, county and basin level for each pollutant. Maximum to average emission rate ratios decreased as the scale of spatial aggregation increased. At the grid cell level, ratios of maximum to average emission rates exceeded 100 in some grid cells for hydrocarbon emissions such as VOCs. In contrast, basin level maximum to average ratios for NOx emission rates were less than 1.1. The sources driving temporal variability for hydrocarbon emissions were well completions and liquid unloadings, while the sources driving temporal variability in NOx emissions were pre-production activities such as drilling and hydraulic fracturing. Accurately reconciling predicted emissions with measurements requires accounting for the timing, duration, and frequency of intermittent events, and depends on the type of measurements being made.