A creep test is a helpful method for investigating the long-term deformation of rock. However, most previous creep tests on rock were carried out for less than a few weeks, and only a handful were performed for longer time periods. This article reports an ongoing long-term creep test that was started in 1997 and reached its twentieth year in 2017. This uniaxial compressive creep test has been conducted with tuff under water at a creep stress of 30 % of its short-term strength. An overview of the creep test is described first in this article, including the test method and long-term maintenance. Daily maintenance and countermeasures against possible problems are indispensable so as to not require halting of the test. During the test, the test apparatus was transferred twice due to the reconstruction of the building containing the laboratory, but the test was not halted during the transfers. The recorded creep strain over a period of 20 years included a variety of environmental noise such as slight changes in the air pressure in the cylinder and in temperature and humidity. Hence, annual averages of the strain were used for understanding the long-term trend, and the trend was found to be approximated by a power function of time. The recorded creep strain was compared with the results of short-term creep tests and the stress-strain curves in strength tests. The authors believe that the test in this study is the longest uniaxial compressive creep test with a rock specimen that has been carried out.
21 March 2024 in Rock Mechanics and Rock Engineering
Creep tests under constant stress are among the most important tests for investigating the time-dependent behavior of rock. In previous studies, creep tests were conducted under various loading and environmental conditions; however, it was very difficult to demonstrate accelerating creep at failure at stresses less than 50% of strength in conventional creep tests. In this study, a new test method is proposed that combines an alternating loading-rate test and a creep test in the post-failure region. The accelerating creep as well as the loading-rate dependence of strength were successfully obtained simultaneously from a single specimen. This test method was applied to three rock types under dry and wet conditions. The results of Sanjome andesite under both dry and wet conditions, Kimachi sandstone under dry conditions, and Tage tuff under dry conditions showed a similar relationship between creep strain, creep strain rate, and residual time (i.e., creep lifetime minus elapsed time), from high to low creep stress levels, and a close relationship between accelerating creep and the loading-rate dependence of strength. Further, the mechanism responsible for the time dependence was found not to change significantly from high to low stress levels. In contrast, different results were obtained when high and low creep stress levels were compared in Kimachi sandstone and Tage tuff under wet conditions. The larger increase in creep strain with increasing creep strain rate at lower creep stress levels was related to the shape of the stress–strain curve in the post-failure region.