Traditional pumped storage capacity configuration uses static, year-targeted approaches, leading under-capacity in the early planning stages—wasting renewable energy—and over-capacity in later stages, thus wasting resources. In order to solve the above problems, this article innovatively proposes a dynamic, time-sequenced construction timeline and annual capacity configuration strategy, synchronized with new energy and load development, enhancing sustainability through optimized investment allocation and efficient resource utilization. It presents a two-layer model that considers multiple scenario operational dispatch. The upper layer aims to minimize the curtailment of wind and solar energy, providing a planning scheme to the lower layer, which focuses on multi-scenario economic dispatch, taking into account the peak-valley difference indicators. The models co-iterate: lower-layer operational outcomes feed back to refine the upper-layer’s capacity plan. This process continues until the predicted curtailment calculated by the upper layer aligns closely with that observed in the lower-layer operational simulations, or until capacity changes stabilize, ultimately determining the optimal time-phased capacity configuration. Simulations on a provincial power grid during three typical scenarios in winter, transitional seasons, and summer, as well as extreme weather scenarios, confirm that timely, dynamic configuration strategy significantly enhances renewable absorption, proving the model’s effectiveness.

In response to the decline in the inertia level of the power system caused by the large-scale integration of new energy, this paper proposes a grid-side pumped storage configuration strategy considering inertia constraints. The general pumped storage configuration ignores the duration of pumped storage and selects only single-duration units for capacity and power configuration. A single unit cannot balance rapid frequency response and long-term energy transfer, forcing thermal power to operate at high costs continuously to provide inertia support, while also causing a sharp increase in wind and solar power curtailment. This paper breaks through the limitations of the traditional single-duration pumped storage configuration and proposes a configuration-operation collaborative optimization strategy that combines inertia constraints and pumped storage duration selection. Firstly, starting from the system’s inertia requirements, the minimum inertia required by the system is obtained, respectively, based on the constraints of the system’s frequency change rate and the lowest point of the frequency. Furthermore, the minimum inertia demand constraint of the power system is constructed, and a capacity configuration strategy for grid-side pumped storage is proposed with the goal of minimizing the total operating cost of the power system throughout its entire cycle, taking into account the penalty term of the peak-valley difference index of the load curve and the penalty of the inertia guarantee value of medium and long-term units, while considering the inertia constraint. Finally, the effectiveness and superiority of the proposed method were verified through simulation analysis.