Pamplona is a city that is crossed by the river Arga along a floodplain, which is susceptible to flooding when there are floods of certain magnitude. In this situation it is important to have a hydrological model able to simulate the flows that runs through the city centre, from the data of different gauges in the watershed, which serve to feed hydraulic models that permits to define the flooding susceptible areas associated to different levels of probability. With this end, the HEC-HMS model of river Arga’s watershed in Pamplona, has been assembled and characterised, and subsequently applied to the five most significant floods in recent years, from which the minimum required data of flow and precipitation is available. HEC-HMS is a rainfallrunoff model that consists of structuring the source watershed into sub-watersheds associated to the river network. The base flow in the observed hydrographs was estimated by the Eckhardt filter. After performing a sensitivity analysis of uncertain parameters of the model (in which it has been observed that CN is the most sensitive) the model has been applied with data from the precipitation series of the automatic stations and data from automatic plus manual stations; in the latter case the results have improved significantly, obtaining satisfactory results.
15 February 2024 in International Journal of Structural Stability and Dynamics
This work presents a new insight into the buckling phenomenon to approach the calculation of the compressed bar with the following firm supports: bi-pinned, bi-fixed, and fixed-pinned. Buckling is redefined as the result of second-order deformations in the real bar by gradually applying the compression load, thus dismissing Euler’s critical load. The analytical results are obtained from the differential equation of the directrix beam with sinusoidal deformation associated with each type of support. The bending moment is generated only by the compression load acting on the initial geometric imperfection. These analytical solutions are associated with first-order effects, applying the entire compressive load, and with second-order effects, applying the load gradually. The analytical solutions are continuous functions. In this paper, the Finite Transfer Method was applied to obtain numerical results. The bending moments, transverse displacements, and normal stresses are presented as the results. Beams with different initial imperfections in the directrix are studied: with sinusoidal deformation, with deformation produced by a specific transverse load, and with deformation produced by a uniform transverse load. The results obtained through the analytical expressions derived from the gradual application of the load are compared with those results obtained numerically when calculating the beam under second-order conditions. It is concluded that in structural practice, they are equivalent.