Haoshen Zhu

Dr. Haoshen Zhu

orcid

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
5 May 2021 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
HCHongchen Chen
Hongchen Chen
HZHaoshen Zhu
Haoshen Zhu
LWLiang Wu
Liang Wu
WCWenquan Che
Wenquan Che
QXQuan Xue
Quan Xue
A wideband low-noise amplifier (LNA) featuring transformer-based wideband input matching is proposed for millimeter-wave applications. By analyzing the properties of conventional series input matching networks, which were widely employed in narrowband LNAs and shunt-series matching networks for bandwidth extension, a novel input matching network possessing the merits of both was proposed. For further bandwidth extension, another peak of input impedance at a higher frequency is introduced for the proposed input matching network. Moreover, it is proved that the proposed input matching network can suppress the gate resistor noise, resulting in significant noise figure (NF) improvement of an LNA. On the other hand, the NF is further reduced by connecting a transformer between the two amplification stages, which helps suppress the noise contribution from the second stage, leading to an LNA design with NF lower than 4.5 dB over a very wide operating bandwidth. To enhance the gain bandwidth, the peak distribution, including both shunt peaking and series peaking, is discussed. By appropriately distributing these peaks, which is also known as the pole-tuning technique, a wider gain bandwidth can be obtained. To validate the proposed techniques, an LNA with two common-source (CS) stages is designed and fabricated using a 65-nm CMOS process, and the overall chip size, including all pads, is only 0.26 mm 2 . The two CS stages are cascoded for dc biasing to reduce the power consumption. Experimental results show that a peak gain of 13.5 dB is achieved within a -3-dB bandwidth from 19.2 to 42.6 GHz. The measured NF is 3.1-4.5 dB, and the input 1-dB gain compression point (IP 1 dB ) ranges from -13.54 to -9.89 dBm in the entire gain bandwidth. The input return loss S 11 is less than -10 dB over a frequency range of 16.8-38.9 GHz. Moreover, benefiting from the current-reuse technique, the power consumption of the LNA is only 6.36 mW.

2 November 2021 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
HCHongchen Chen
Hongchen Chen
HZHaoshen Zhu
Haoshen Zhu
LWLiang Wu
Liang Wu
QXQuan Xue
Quan Xue
WCWenquan Che
Wenquan Che
A wideband low-noise amplifier (LNA) with low and flat noise figure (NF) is presented in this article. For conventional wideband noise matching, the noise performance in the high-frequency region of the entire wideband is usually deteriorated due to the frequency-dependent nature of the minimum noise figure (NF min ) for a MOSFET. To address this issue, a novel wideband noise matching approach aiming at noise matching in high band is proposed. This approach can reduce the NF in high band at the cost of a slight NF increase in low band, eventually achieving a low and flat NF and thus a better overall noise performance for a wideband LNA. In addition, the multistage noise matching technique is employed at high frequencies to further reduce the NF caused by the second amplification stage. To validate the proposed techniques, a two-stage LNA prototype was designed and fabricated using a 65 nm CMOS process. The experimental results indicate a peak gain of 16.6 dB with a −3 dB bandwidth (BW) from 7.2 to 27.3 GHz (a fractional BW of 116%). Within the entire band of interest, the simulated NF is low and almost constant (3.3–3.4 dB), while the measured NF falls within the range of 3.30–3.72 dB. Considering the uncertainty of NF measurement, a 0.21 dB NF flatness is one of the best results among the reported millimeter-wave wideband LNAs. The measured third-order input intercept point (IIP3) is −6 dBm at 20 GHz, while the power consumption is 13.2 mW. In addition, only two passive transformers are used in this design, leading to a compact chip core area (0.14 mm 2 ).

1 June 2017 in IEEE Electron Device Letters
Verified
Journal Article
Closed access
HZHaoshen Zhu
Haoshen Zhu
MRMina Rais-Zadeh
Mina Rais-Zadeh
This letter reports on first-time demonstration of non-reciprocal acoustic transmission in a gallium nitride (GaN) delay line structure. The split of forward (S21) and backward (S12) transmissions is observed by applying a dc electric field through the active area with a two-dimensional electron gas (2DEG) sheet. The non-reciprocity (~20.7 dB/mm max. in this letter) varies by tuning the gate voltage to deplete the 2DEG sheet carrier density, which agrees with model prediction for the interaction between 2DEG and surface acoustic waves. Our preliminary results prove the feasibility of implementing chip-scale non-reciprocal acoustic devices in a GaN platform through acoustoelectric amplification.

16 July 2021 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
YJYan Jiang
Yan Jiang
LFLinping Feng
Linping Feng
HZHaoshen Zhu
Haoshen Zhu
WFWenjie Feng
Wenjie Feng
HCHaidong Chen
Haidong Chen
QXQuan Xue
Quan Xue
In this brief, a novel bandpass filter (BPF) with ultra-wide upper stopband performance is proposed and implemented on gallium arsenide (GaAs) integrated passive device (IPD) technology. Firstly, the proposed BPF is designed by introducing a $\boldsymbol{\pi }$ -section to achieve an ultra-wide upper stopband. Following that, the working principle of achieving this ultra-wideband upper stopband performance is further investigated. Finally, to demonstrate the claimed performances, this BPF with a size of $1.63 {\mathrm {\times }}0.62$ mm 2 has been fabricated on GaAs IPD technology and measured by on-wafer probing. The measured BPF with a 3-dB fractional bandwidth (FBW) of 95.3% (1.7-4.8 GHz), exhibits the expected performances, especially the superior upper stopband suppression level better than 20 dB until 110 GHz (34.6 ${f} _{0}$ ). The simulated and measured results of the BPF are in reasonably good agreement, thus firmly validating the claimed superior performances of the BPF in terms of good frequency selectivity and ultra-wide upper stopband.

30 January 2023 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
FQFeng Qiu
Feng Qiu
HZHaoshen Zhu
Haoshen Zhu
WCWenquan Che
Wenquan Che
QXQuan Xue
Quan Xue
A novel non-orthogonal vector summing method is proposed and used to design phase shifter (PS) with low phase error and high phase resolution. The principle and topology of the proposed method are first investigated, while the calculation results indicate less sensitivity from phase error to magnitude mismatch than the conventional orthogonal vector summing method. A non-orthogonal vector generator with low phase and magnitude error is further designed to implement the proposed non-orthogonal vector summing. For demonstration, a $K$ -band full 360 $^{\circ}$ PS with the phase resolution of 3.75 $^{\circ}$ is implemented in a 65-nm CMOS process with the core chip size of 0.15 mm $^{2}$ . The results show a 0.75 $^{\circ}$ –2.08 $^{\circ}$ rms phase error and a 0.8–0.95-dB rms voltage gain error, while the total power consumption is 16 mW under a 1.2-V voltage supply.

20 April 2021 in IEEE Transactions on Circuits and Systems II: Express Briefs
Verified
Journal Article
Closed access
FQFeng Qiu
Feng Qiu
HZHaoshen Zhu
Haoshen Zhu
LWLiang Wu
Liang Wu
WCWenquan Che
Wenquan Che
QXQuan Xue
Quan Xue
This brief presents a 15–38 GHz vector-summing phase shifter (VSPS) with the full 360° phase-shifting range in the 65nm CMOS process. An improved wideband quadrature all-pass filter (QAF) is designed to overcome the traditional one’s capacitive loading effect and exhibits wideband I/Q performance. Analysis and comparison between the proposed QAF and the traditional one are discussed. For demonstration, a prototype VSPS with the full 360° phase-shifting range from 15GHz to 38GHz using the proposed QAF is implemented in the 65nm CMOS process. The root means square (RMS) phase and gain errors are 2°~3.5° and 0.7 dB ~1 dB from 15 GHz to 38 GHz, respectively. The power consumption is 19.2mW, and the whole chip is compact with a core size of 0.16mm 2 .