JAESUNG MOON

Dr. JAESUNG MOON

orcid

Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 February 2024 in Journal of Advanced Marine Engineering and Technology
Verified
Journal Article
Open access
MJMin-A Je
Min-A Je
SJSuk-Ho Jung
Suk-Ho Jung
TJTae-Young Jeong
Tae-Young Jeong
SHSung-Chul Hwang
Sung-Chul Hwang
JMJAESUNG MOON
JAESUNG MOON

Verified
Journal Article
Open access
PDF file
JMJAESUNG MOON
JAESUNG MOON
This study presents a comparative investigation of combustion and emission characteristics in a two-stroke MAN 5S35ME-B9.5 marine diesel engine equipped with a Controllable Pitch Propeller and an Exhaust Gas Recirculation system. Experimental data were obtained from both factory shop tests conducted under the IMO NOx Technical Code 2008 E2 cycle and sea trials performed onboard the T/S Baek-Kyung. Engine performance was evaluated under Tier II-FB, ecoEGR, and Tier III modes, focusing on specific fuel oil consumption, peak cylinder pressure, exhaust gas temperature, and regulated emissions. Results indicate that Tier III achieved the greatest NOx abatement, reducing emissions by up to 76.4% (1464 to 346 ppm), but with penalties of 16.8% higher SFOC and 45.2% higher CO2 concentration. EcoEGR provided a more favorable compromise, reducing NOx by 52.3% while limiting SFOC increases to ≤15.4% and CO2 increases to ≤30.9%. Strong correlations were observed between NOx, Pmax, and exhaust gas temperature, reaffirming fundamental trade-offs, while O2 and CO correlations showed greater variability under sea operation. Despite operational scatter, sea trial results reproduced the key patterns observed in shop tests, confirming robustness across conditions. Overall, this correlation-based analysis provides quantified evidence of performance–emission trade-offs and offers a practical foundation for optimizing CPP-equipped two-stroke engines under varying EGR strategies.

Verified
Journal Article
Open access
PDF file
JMJAESUNG MOON
JAESUNG MOON
This study experimentally investigates the performance and exhaust emission characteristics of a low-speed two-stroke marine diesel engine operated with different controllable pitch propeller (CPP) modes during actual sea operation. Full-scale measurements were conducted on the training vessel T/S Baek-Kyung, equipped with a MAN B&W 5S35ME-B9.5 engine, operating under IMO Tier II fallback (FB) conditions. Two CPP control strategies were compared: a constant-speed mode, in which engine speed was maintained at approximately 162 rpm and load was controlled by propeller pitch, and a combinator mode, in which engine speed and pitch were jointly controlled. In the combinator mode, the propeller pitch reached saturation (100%) at approximately 25% load, and further load variation was governed primarily by engine speed. The analysis focused on an engine-load range of approximately 25–75% SMCR and evaluated propulsion performance, including specific fuel oil consumption (SFOC) and shaft torque, together with estimated brake-specific exhaust emissions expressed in g/kWh. The combinator mode achieved superior fuel efficiency under partial-load conditions, reducing SFOC by up to 10.5 g/kWh (5.4%) at 25% load, while increasing shaft torque by up to 47%, indicating improved engine–propeller matching. However, this benefit was accompanied by higher estimated emissions at low load, with BSNOx increasing from 13.61 to 16.95 g/kWh. As engine load increased, differences in both performance and emissions between the two modes diminished. These results reveal a clear load-dependent trade-off between fuel efficiency and exhaust emissions in CPP operation and emphasize the importance of load-based switching or optimal joint control strategies under off-design conditions.

30 June 2025 in Journal of Power System Engineering
Verified
Journal Article
Closed access
JMJAESUNG MOON
JAESUNG MOON
SJSuk-Ho Jung
Suk-Ho Jung
현존 선박에도 온실가스를 저감하는 방안을 적용하기 위해 CII가 적용되었다. CII 등급을 결정하는 수식에는 연료 종별로 CO₂ 전환계수가 정해져 있어 실제 연료의 온실가스 배출량을 완벽하게 제시한다고 하기는 어렵다. 따라서 CO₂ 전환계수가 온실가스 배출량을 잘 반영하는 것을 뒷받침하는 연구가 많이 필요하다. 본 연구에서는 천연가스의 질량분율에 따라 사용된 연료량을 기준으로 산출한 CO₂ 배출량과 배기가스에서 측정된 CO₂ 배출량을 비교하여 CII 등급에 미치는 영향을 분석하였다. 그 결과 MARPOL에서 정한 CO₂ 전환계수에 천연가스 질량분율에 따른 CO₂ 배출 저감율이 0.0032x이고, 연료량을 기준으로 산출한 저감율은 0.0053x, 측정된 CO₂ 배출량을 기준으로 산출한 저감율은 0.0034x 였다. 따라서 사용된 연료량을 기준으로 CF를 적용하여 CII를 산출하는 것이 유리하다. 이를 바탕으로 2026년 백경호의 CII 등급을 산출한 결과, D등급으로 예상되지만 측정값을 기준으로 산출한 경우, 60% 이상의 천연가스를 사용하면 A등급이 될 수 있고, 사용된 연료량을 기준으로 산출하면 40% 이내의 천연가스를 사용해도 A등급이 될 수 있다는 것을 확인하였다.

Verified
Journal Article
Open access
PDF file
JMJAESUNG MOON
JAESUNG MOON
JCJeongmin Cheon
Jeongmin Cheon
This study examines operating-point alignment during full-scale sea trials of a controllable pitch propeller (CPP)-equipped vessel by reconstructing engine load from measured shaft power and relating it to engine performance, fuel-consumption behavior, and combustion indicators. Engine-side performance and fuel-oil consumption records were integrated with shaft measurement data for a MAN 5S35ME-B9.5 low-speed two-stroke marine diesel engine to establish a common propulsion-based operating-point framework. The average shaft power at the 100% speed-trial point was 3471.1 kW, differing from the rated power by only −0.11%, and was adopted as the reference for shaft-load reconstruction. The reconstructed speed-trial operating points were aligned at 24.91%, 49.04%, 80.85%, and 100.00%, while the endurance points corresponded to 76.99% at NCR and 95.29% at MCR. Relative to the corresponding speed-trial references, the endurance points showed about 4.7% lower delivered shaft power, indicating that they should not be interpreted as identical to nominal speed-trial load labels. Fuel flow and combustion-related indicators showed physically consistent variation with increasing reconstructed load. These results demonstrate that measured shaft power provides a practical basis for harmonizing sea-trial datasets and for distinguishing propulsion-side operating conditions more consistently than nominal load labels alone. The proposed framework is particularly applicable to representative operating-point alignment in full-scale sea trials of CPP-equipped low-speed two-stroke marine diesel engines under comparable test conditions.