Switch rails are indispensable components of high speed railway systems, which have stringent nondestructive testing requirements owing to the severe operating conditions. In this article, an ultrasonic guided wave method is proposed for defect detection and localization using independent component analysis (ICA). The temperature effect is included in the data matrix by a random selection of the signals measured at different temperatures. A damage index named the average standard Euclidian distance (ASED) is used to evaluate the deviations of the test signals from the baseline signals in the feature space consisting of the independent components for the defect detection. Once the defect existence is found, defect localization is conducted by another ICA-based decomposition of a new data matrix with additional test signals for the same defect. Independent components whose coefficient vectors show a high correlation with the standard step change vector are chosen to construct the ICA-based residual signal. Then the time instance and location of the defect is determined by observing the first very high peak occurring in the residual signals. A detectability index for defect location (DIDL) is proposed. Experimental validations are performed for the defects on the foot and web of a switch rail. The results of the ASED curves clearly indicate the existence of artificial defects, and the ICA-based residual signals show the location of the defects. The proposed method is found to be superior to conventional methods such as simple baseline subtraction and optimal baseline subtraction regarding the DIDL.
Magnetostrictive patch transducers (MPT) with planar coils are ideal candidates for shear mode generation and detection in pipe and plate inspection with the advantages of flexibility, lightness and good directivity. However, the low energy conversion efficiency limits the application of the MPT in long distance inspection. In this article, a method for the enhancement of the MPT was proposed by dynamic magnetic field optimization using a soft magnetic patch (SMP). The SMP can reduce the magnetic resistance of the magnetic circuit, which increases the dynamic magnetic field intensity in the magnetostrictive patch during wave generation and restricts the induced dynamic magnetic field within the area around the coils for sensing during wave detection. Numerical simulations carried out at different frequencies verified the improvement of the dynamic magnetic fields by the SMP and influence of different affecting factors. The experimental validations of the signal enhancement in wave generation and detection were performed in an aluminum plate. The amplitude magnification could reach 12.7 dB when the MPTs were covered by the SMPs. Based on the numerical and experimental results, the SMP with a large relative permeability and thickness and close fitting between the SMP and coils were recommended when other application conditions were met.
Tanks are essential facilities for oil and chemical storage and transportation. As indispensable parts, the tank floors have stringent nondestructive testing requirements owing to their severe operating conditions. In this article, a synthetic aperture focusing technology method is proposed for the circumferential scanning of the tank floor from the edge outside the tank using ultrasonic guided waves. The zeroth shear horizontal (SH0) mode is selected as an ideal candidate for plate inspection, and the magnetostrictive sandwich transducer (MST) is designed and manufactured for the generation and receiving of the SH0 mode. Based on the exploding reflector model (ERM), the relationships between guided wave fields at different radii of polar coordinates are derived in the frequency domain. The defect spot is focused when the sound field is calculated at the radius of the defect. Numerical and experimental validations are performed for the defect inspection in an iron plate. The angular bandwidth of the defect spot is used as an index for the angular resolution. The results of the proposed method show significant improvement compared to those obtained by the B-scan method, and it is found to be superior to the conventional method—named delay and sum (DAS)—in both angular resolution and calculation efficiency.