This paper introduces a dual-band planar microwave sensor system for measuring the complex dielectric constant of solid material. The sensor system comprises three constituent parts: the sensing probe, the circuit module and the broadband coupler. The sensing probe is composed of a host part and a sensing area. The host part is composed of a microstrip line, which facilitates system integration with other planar microwave components. The sensing area comprises two pairs of E-interdigital structures, which were originally developed from the interdigital capacitor. This configuration manifests two resonant frequency points, specifically 3 GHz and 3.92 GHz. Consequently, any environmental effects exhibit equivalent variation at both resonant frequency points, thereby substantiating the efficacy of the proposed sensor system for differential operation, which has the capacity to mitigate the impact of environmental conditions. The circuit module comprises a controller, two detectors and a signal generator, which facilitate the generation and processing of radio frequency signals within the system. The function of the broadband coupler is to differentiate between the incident signal and the reflected signal. The operating principle is predicated on the variation in the resonant frequency and peak attenuation with respect to the complex dielectric constant of the material under test (MUT). In order to validate the effectiveness of the proposed sensor system, a prototype is fabricated and tested. The proposed sensor system is distinguished by its high sensitivity and low cost. The apparatus is capable of performing measurements independently and without the necessity for auxiliary equipment.
This article proposes a strategy for realizing of a microwave sensor that operates in transmission mode and is suitable for measuring small perturbations in relative permittivity, based on the measurement of the phase of the transmission coefficient at a single frequency. The sensor introduces the waveguide-metamaterial (WG-MTM) equivalent lumped element theory, equating the material under test (MUT) with different relative permittivities to lumped elements. The structure of a substrate-integrated waveguide (SIW) narrow-wall directional coupler is adopted, employing MUTs with varying relative permittivities as reflective elements to generate phase variations. It demonstrates high sensitivity( fp = 110GHz , S = 707° ) when the effective relative permittivity of the MUT equals to that of the waveguide. The paper presents a comprehensive analysis that supports this conclusion. Subsequently, four prototype sensors have been designed and fabricated for verification. Compared to other transmission-mode phase-variation microwave sensors, the proposed sensor features a simplified design and a significantly reduced physical size of the sensing region, while minimizing waste during the detection of powdered materials. Experimental results confirm the sensor’s capability for characterizing the permittivity of solids and powders, with potential extension to liquid dielectric analysis, suggesting versatile applicability in material sensing systems.
21 September 2025 in International Journal of Circuit Theory and Applications
This paper presents a sensor system for measuring the dielectric constant of materials, with a control circuit, a broadband coupler and a sensing probe as its main components. The entire system can independently measure the dielectric constant of powdered solid materials and liquid materials without relying on any auxiliary equipment. According to the transmission line design theory, the sensing probe utilizes a short-ended transmission line based on air coplanar waveguide. By introducing a parallel resistor at the input of the transmission line, material under test (MUT) with different dielectric constant can directly influence the resonance frequency of the transmission line’s reflection coefficient. The dielectric constant can be inverted through the measurement of the resonance frequency. This paper systematically analyzes the sufficient condition for the validity of the conclusion and discusses interference factors that may affect the measurement result, such as variation in resistor value and difference in material loss. Subsequently, a dedicated control circuit was designed and manufactured by integrating a control chip, an RF chip, and a detector, thus forming a low-cost, portable sensor system together with the sensing probe and coupler. Experimental tests were conducted on six different MUTs, and the results confirmed that the system has the capability to accurately characterize the dielectric constant of powdered solid and liquid material. Compared to other sensor systems, the proposed system features a simplified design and higher measurement precision, indicating its broad applicability in radio frequency identification.