Forward modeling of diffraction peaks is a potential way to compare the results of theoretical mechanical simulations and experimental X-ray diffraction (XRD) data recorded during in situ experiments. As the input data are the strain or displacement field within a representative volume of the material containing dislocations, a computer-aided efficient and accurate method to generate these fields is necessary. With this aim, a current and promising numerical method is based on the use of the fast Fourier transform (FFT)-based method. However, classic FFT-based methods present some numerical artifacts due to the Gibbs phenomenon or “aliasing” and to “voxelization” effects. Here, we propose several improvements: first, a consistent discrete Green operator to remove “aliasing” effects; and second, a method to minimize the voxelization artifacts generated by dislocation loops inclined with respect to the computational grid. Then, we show the effect of these improvements on theoretical diffraction peaks.
The high-temperature creep behavior of a rafted [001] oriented AM1 Ni-based single crystal superalloy was investigated during in situ creep tests on synchrotrons. Experiments were performed at constant temperatures under variable applied stress in order to study the response (plastic strain, load transfer) to stress jumps. Using two different diffraction techniques in transmission (Laue) geometry, it was possible to measure the average lattice parameters of both the matrix and the rafts in the [100] direction at intervals shorter than 300 s. The absolute precision with both diffraction techniques of the constrained transverse mismatch (in the rafts’ plane) is about 10−5. After stress jumps, special attention is given to the evolution of plastic strain within the channels. The relaxation of the Von Mises stress at leveled applied stress shows evidence of dislocation multiplication within the channels. From the analysis, we showed an interaction between plastic stress and dislocation density of the phase.
The combination of in situ high resolution diffraction experiments with synchrotron radiation and mechanical and diffraction modelling is used to investigate the microstructure and mechanical state of single crystal superalloys during high temperature tests: a very high temperature annealing without external load and a creep test.