Humanoid robotics attracted the attention of many researchers in the past 35 years. The motivation of research is the suitability of the biped structure for tasks in the human environment. The control of a biped humanoid is a challenging task due to the hard-to-stabilize dynamics. Walking reference trajectory generation is one of the key problems. The zero moment point (ZMP) criterion is widely employed in the stability analysis of biped robot walk. Linear inverted pendulum model (LIPM) based reference generation obtained by applying the ZMP criterion are reported in the literature. In these methods, generally, the ZMP during a stepping motion is kept fixed in the middle of the supporting foot sole. This paper employs a reference generation algorithm based on the linear inverted pendulum model (LIPM) and moving support foot ZMP references. This kind of reference generation possesses naturalness, in that, the ZMP in the human walk does not stay fixed, but it moves forward, under the supporting foot. The application of Fourier series approximation simplifies the solution and it generates a smooth ZMP reference. A suitable swing foot reference is employed too. A number of modes of trajectory and force control methods for locomotion are devised and applied. The developed techniques are tested through simulation with a 12 DOF biped robot model. The results obtained are promising for implementations
An important engineering challenge is the design of a wind turbine’s pitch angle controller. The dependability, safety, and power output maximization of a wind turbine are all impacted by this controller. In this study, a 2 MW doubly fed induction generator wind turbine’s blade angle controller design with a novel fuzzy logic controller is tested in a simulated environment. The evolutionary algorithm technique is used to optimize the fuzzy logic controller with three inputs. A genetic algorithm is used to optimize the specified pitch angle controller for a number of coefficients. After the optimization process, the controller’s performance is assessed in terms of power output, overshoot, and steady-state error characteristics.
This paper presents a novel method for joint sensor faults detection and faulty signal reconstruction. It uses the Virtual Joint Sensor (VJS). The model structure of the VJS consists of two interconnected models: The simple Linear Inverted Pendulum Model (LIPM) and the robot leg kinematics model (LKM). Kalman filter based on LIPM estimates the Center of Mass (CoM) position of the biped. The LKM uses the estimated CoM position to calculate the joints angles. A faulty signal model is formed to detect the faults, based on an adaptive threshold, and recovers the signal using the VJS outputs. The sensor abrupt, incipient, and frozen output faults are studied and tested. The validity of the proposed method was confirmed by simulations on 3D dynamics model of the humanoid robot SURALP while walking on a flat terrain.
Bipedal locomotion has good obstacle avoidance properties. A robot with human appearance has advantages in human-robot communication. However, walking control is difficult due to the complex robot dynamics involved. Stable reference generation is significant in walking control. The Linear Inverted Pendulum Model (LIPM) and the Zero Moment Point (ZMP) criterion are applied in a number of studies for stable walking reference generation of biped robots. This is the main route of reference generation in this paper too. We employ a natural and continuous ZMP reference trajectory for a stable and human-like walk. The ZMP reference trajectories move forward under the sole of the support foot when the robot body is supported by a single leg. Robot center of mass (CoM) trajectory is obtained from predefined ZMP reference trajectories by Fourier series approximation. We reported simulation results with this algorithm in our previous works. This paper presents the first experimental results. Also the use of a ground push phase before foot take-offs reported in our previous works is tested first time together with our ZMP based reference trajectory. The reference generation strategy is tested via walking experiments on the 29 degrees-of-freedom (DOF) human sized full body humanoid robot SURALP (Sabanci University Robotics Research Laboratory Platform). Experiments indicate that the proposed reference trajectory generation technique is successful.