Lorenzo Bonzi

Dr. Lorenzo Bonzi

orcid

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 October 2024 in Agricultural Water Management
Verified
Journal Article
Open access
FHFatma Hamouda
Fatma Hamouda
ÀPÀngela Puig-Sirera
Àngela Puig-Sirera
Lorenzo BonziLorenzo Bonzi
Lorenzo Bonzi
DRDamiano Remorini
Damiano Remorini
RMRossano Massai
Rossano Massai
Giovanni RalloGiovanni Rallo
Giovanni Rallo

4 July 2023 in Computers and Electronics in Agriculture
Verified
Journal Article
Open access
ÀPÀngela Puig-Sirera
Àngela Puig-Sirera
Lorenzo BonziLorenzo Bonzi
Lorenzo Bonzi
LCLorenzo Cotrozzi
Lorenzo Cotrozzi
FHFatma Hamouda
Fatma Hamouda
AMAlessandra Marchica
Alessandra Marchica
Giovanni RalloGiovanni Rallo
Giovanni Rallo

20 January 2025
Verified
Conference Paper
Open access
MCMarco Carrara
Marco Carrara
Lorenzo BonziLorenzo Bonzi
Lorenzo Bonzi
FHFatma Hamouda
Fatma Hamouda
MSMino Sportelli
Mino Sportelli
ÀPÀngela Puig-Sirera
Àngela Puig-Sirera
Giovanni RalloGiovanni Rallo
Giovanni Rallo
This study aimed to assess and compare the performance of EM38 (Geonics Limited) and Syscal-Pro (Iris instruments) EMI tools in soil spatial heterogeneity mapping. Mainly, the two tools were evaluated for their ability to explain the spatial variability of the soil resistivity, which strongly correlates with the soil’s physical status properties. Moreover, the effect of two surface soil roughness caused by two different tillage modalities has been studied.The experimental plot (30 m width x 100 m length) consisted of an agroforestry system located in San Piero a Grado (Pisa, Italy, (, 43°41’07” N, 10°20’32” E). Two 100-meters length deep open drains were located on the edges. The soil texture is loam, with clay content values from 7.64% to 15.14% and sand content ranging from 22.36% to 49.37%. The intercropping system consisted of wheat (Triticum aestivum L) and pea (Pisum Sativum L) in the inner part of the field, and two rows of poplar (Populus x euramericana Dode Guiner) on the edges experimental plot.Data were acquired before seed-bed preparation by pulling the two tools over the soil. For the Syscal-pro, 13 cylindrical stainless-steel electrodes were pulled by a tractor, allowing soil resistivity data acquisition according to the reciprocal Wenner-Schlumberger array (Telford, 1976). A total of five transects with 5 m spacing were spanned to the inner field zone, whereas four additional transects allowed to detail the resistivity gradients closed the two deep open drains.Regarding the EM38 tool, a preliminary laboratory activity allowed the development of a specific data acquisition (DAQ) system for continuous monitoring of the resistivity data recording and spatializing. This DAQ system is based on a CR1000 Data logger (Campbell Scientific, United States), which allows collecting the speed and position of the EM-38 device by carrying it on a specifically designed sled system.Two Garmin’s GPS (model 79S/SC for Syscal Pro and model GPS16X-HVS for the EM38) enabled georeferencing the collected data.Preliminary results have shown a range of electrical conductivity values between 30 mS/m and 45 mS/m, spatially distributed according to the pattern obtained by Syscal-Pro. Further investigation is required to better understand the relationship between EM38 and Syscal-Pro measurements, after which the vertical domain explored has been standardised between the two methods.Keywords: Agroforestry system, EM38, Syscal, soil bulk resistivity, soil bulk conductivity, spatial variability.

20 January 2025
Verified
Conference Paper
Open access
EDEmanuele Dichio
Emanuele Dichio
Lorenzo BonziLorenzo Bonzi
Lorenzo Bonzi
Giovanni RalloGiovanni Rallo
Giovanni Rallo
ÀPÀngela Puig-Sirera
Àngela Puig-Sirera
DRDamiano Remorini
Damiano Remorini
RMRossano Massai
Rossano Massai
Abstract The weather-based approach quantifies the crop water requirements (CWR) using a simplified agrohydrological model coupled with meteorological sensors. The FAO56 model (Allen et al., 1998) is one of the most used bucket models for CWR. In this model, the daily ET0 is usually estimated by the FAO-Penman-Monteith (PM), which needs as inputs standard atmosphere forcings acquired from weather stations, that often are equipped with ordinary mechatronics sensors that require regular maintenance. An atmometer (ETgage) is an accurate sensor with no moving parts that continuously measures the ET0 based on a physical analogy of the crop reference. This study aims to design and validate an expert system, named Irrigatmo, to manage irrigation based on the combined application of the feedforward- (FFc) and feedback- (FBc) control irrigation scheduling protocols. The FFc protocol comprises a Kc-based mass balance model with a modified atmometer and FDR sensors for sub-hourly ET0 and soil water content (SWC) measurements. At the same time, the FBc protocol uses the SWC to quantify the critical condition and the crop stress coefficient to adjust the Kcb value used in the bucket model. The system was implemented in proprietary logic (CR300, Campbell Scientific Inc.) and open-source logic (Arduino Mega 2560, Arduino). The core of the system implements a weather-based water balance model, trained by a modified atmometer and soil moisture sensor for sub-hourly scale ET0 and SWC, as well as an infrared thermometer and a contact thermocouple for quantifying the crop water stress index (CWSI). The ETgage was modified by integrating a pressure transducer sensor, calibrated to measure the water level inside the atmometer tank continuously. The results showed that Irrigatmo accurately and rapidly detected the changes in atmospheric and soil water conditions. The system can directly calculate the evapotranspiration reduction factor (Ks), estimating the CWSI based on canopy temperature measurements. This could overcome the uncertainty in the models associated with the water stress function based solely on the soil moisture. The system was built and calibrated within the AgrHySMo laboratory of DiSAAA-a and validated on a commercial kiwifruit orchard of Actinidia chinensis var. chinensis 'Zesy002'. The field testing made it possible to validate the system's ability to model the water stress functions of the crop and the sensitivity to identify the critical water status conditions that mark the transition to a limiting condition. Irrigatmo could manage irrigation autonomously, activating or turning off the solenoid valves, and returning to our field the amount of water lost during the evapotranspiration processes. Future perspectives consider the implementation of the proposed system in a wireless sensor network (WSN) and at the interfacing of the WSN nodes with aerial platforms where the edge-computing systems specialized also in the control of IoT-irrigation actuators will be located.

9 June 2026 in SSRN Electronic Journal
Verified
Preprint
Open access
Lorenzo BonziLorenzo Bonzi
Lorenzo Bonzi
DEDichio E.
Dichio E.
HFHamouda F.
Hamouda F.
APAngela Puig-Sirera
Angela Puig-Sirera
GRGiovanni Rallo
Giovanni Rallo
Accurate estimation of reference evapotranspiration (ET₀) is fundamental for optimizing irrigation scheduling and water resource management in agriculture. Traditional atmometers (ETgage) offer an affordable alternative to complex instruments but are limited by low temporal resolution and discrete measurement intervals. This study presents a novel approach to overcome these limitations by integrating pressure transducers into the atmometer system, enabling continuous, high-frequency monitoring of water-level changes in the reservoir.,Four pressure transducers with varying sensitivities were tested under controlled laboratory conditions using a high-precision metrology bench. The most responsive sensor, model RS-828-5708, was selected for calibration linearity and signal stability and deployed in a commercial kiwifruit orchard for field validation. The enhanced atmometer showed strong agreement with Penman-Monteith-based ET₀ estimates, particularly at the daily scale, while providing improved responsiveness to short-term fluctuations in vapour pressure deficit and other environmental drivers.,Several statistical adjustment models were developed using ground-based and satellite-derived solar radiation inputs to address observed discrepancies under high radiation and dry conditions. The pyranometer-based model exhibited the highest accuracy (R² = 0.993; RMSE = 0.0073 mm h⁻¹).,This integrated sensing system offers a cost-effective and scalable solution for real-time evapotranspiration monitoring, bridging the gap between low-cost field tools and data-intensive decision-making in precision agriculture.

1 July 2023
Verified
Book Chapter
Closed access
PDF file
Lorenzo BonziLorenzo Bonzi
Lorenzo Bonzi
FHFatma Hamouda
Fatma Hamouda
ÀPÀngela Puig-Sirera
Àngela Puig-Sirera
ASAndrea Sbrana
Andrea Sbrana
DRDamiano Remorini
Damiano Remorini
GRGiovanni Rallo
Giovanni Rallo