Fuxiang Zhang

Prof. Dr. Fuxiang Zhang


Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 November 2019 in Journal Européen des Systèmes Automatisés
Verified
Journal Article
Closed access
FDFei Deng
Fei Deng
XLXiaoyang Liu
Xiaoyang Liu
NZNuo Zhang
Nuo Zhang
FZFuxiang Zhang
Fuxiang Zhang

7 January 2026 in Applied Sciences
Verified
Journal Article
Open access
PDF file
JDJiangtao Jiangtao Dong
Jiangtao Jiangtao Dong
FZFuxiang Zhang
Fuxiang Zhang
FHFengshan Huang
Fengshan Huang
XMXiaofei Man
Xiaofei Man
To enhance the accuracy of discrete element method (DEM) simulation for the snow removal process performed by autonomous robots on membrane structures, this study calibrated the key contact parameters of snow particles used in the simulation. Through literature research, the intrinsic parameters and contact parameter ranges for snow particles and membrane structures were determined. A discrete element model of snow particles was established, and the Hertz–Mindlin with Johnson–Kendall–Robert contact model was selected to simulate the formation process of the repose angle. Using the actual repose angle of snow particles as the target, four significant factors were identified through the P-B experiment, and other factors were set at the intermediate level. Through the steepest slope climbing experiment and response surface design, second-order response equations of the four significant factors were obtained. The optimal parameter combination was calculated as follows: the surface energy of snow particles was 0.23 J/m2; the restitution coefficient, static friction coefficient, and rolling friction coefficient of snow–snow were 0.141, 0.05, and 0.03; and the restitution coefficient, static friction coefficient, and rolling friction coefficient of snow–membrane were 0.2, 0.18, and 0.03. The simulated repose angle was 40.62°, and the relative error with the actual repose angle was 0.32%. These calibration results are reliable and can provide a reliable simulation basis and essential data support for the optimal design of a snow removal robot and the dynamic simulation of the operation process.

1 May 2024 in Journal of Computer-Aided Design & Computer Graphics
Verified
Journal Article
Open access
PDF file
FZFuxiang Zhang
Fuxiang Zhang
HSHesheng Sun
Hesheng Sun
YHYongjian Huang
Yongjian Huang
FHFengshan Huang
Fengshan Huang
Aiming at the difficulty and low efficiency of end face center position measurement in the end face labeling process of bundled bars, a method of end face positioning of bundled bars based on point cloud partitioning statistics is proposed. Firstly, the end face point cloud is pre-processed; then the end face point cloud is segmented using an improved clustering segmentation algorithm, and a method for locating the endface centre of complete single bar and a method for locating the endface centre of defective single bar based on the zoning statistics are proposed to achieve end face center localization; finally, the end face normal vector is used instead of the endface center pose for end face center pose reconstruction. 200 single bar end face point clouds with different pose were collected for the experiment, the time to locate a single bar endface was less than 0.5 s, the position error was less than 3 mm, and the posture error was within 2°. The results show that the proposed method is efficient and can accurately locate the bar endface centre.