Aiming at addressing the problem of dust generated when grab is unloaded, the flow field characteristics of fugitive dust in an open space were studied and reflected its unstable and complex nonlinear dynamic process. Using coal, sand, and flour as research objects, an experimental model and measurement system for grab unloading were built, and the dust diffusion range, diffusion speed and direction, settling time, dust concentration, and induced wind velocity at different measurement points were compared. The computational fluid dynamics–discrete element method (CFD-DEM) coupling method was adopted, the discrete phase model (DPM) of dust was established, the interaction of the particle, dust, and airflow fields during the unloading process of the grab was further studied, and the distribution and diffusion laws of the induced airflow and dust were obtained. The acquisition of flow field characteristics is of great significance for controlling and guiding the orderly deposition of dust.

Aramid fiber is increasingly regarded as an important skeleton material in the conveyor belt industry. However, its application is limited by problems such as short splice service life and low strength retention. This study investigates the finger splice of an aramid rubber conveyor belt. A finite element model was established to analyze the effects of different rubber hardness values (60, 65, 70, 75), environmental temperatures (−20 to 40 °C), and finger widths (10 mm, 12 mm, 15 mm, 20 mm, 30 mm) on splice mechanical performance. The results show that the maximum stress is concentrated at the end surfaces of the reinforcement layer and the fingertips of the skeleton material. The splice strength increases with higher rubber hardness but decreases with rising environmental temperature. To improve splice strength, the rubber hardness and environmental temperature should be controlled within 60–70 and 0–20 °C, respectively. Although reducing finger width increases splice strength, excessively small widths lead to stress concentration and manufacturing difficulties. Therefore, finger width selection should consider actual working conditions. The experimental results are compared with simulation results, and the trend consistency verifies the correctness of the simulation. This study provides a theoretical basis for parameter selection and structural design of the splice under various working conditions.