Well-killing operations in water-sensitive hydrophilic formations are often complicated by extended well clean-up periods and, in some cases, failure to restore the well’s production potential post-kill. Typical development targets exhibiting these properties include the Neocomian and Jurassic deposits of fields in Western Siberia and Western Kazakhstan. This paper proposes a well-killing method incorporating simultaneous near-wellbore treatment. In cases where heavy oil components (asphaltenes, resins, or paraffins) are deposited in the near-wellbore zone, their removal with a solvent results in post-operation flow rates that exceed pre-restoration levels. For wells not affected by asphaltene, resin, and paraffin deposits, killing is performed using a blocking pill of invert emulsion stabilized with an emulsifier and hydrophobic nanosilica. During filtration into the formation, this emulsion does not break but rather reforms according to the pore throat sizes. Flow rates in such wells typically match pre-restoration levels. The described engineering solution proves less effective when the well fluid water cut exceeds 60%. For wells exhibiting premature water breakthrough that have not yet produced their estimated oil volume, the water source is identified, and water shutoff operations are conducted. This involves polymer-gel systems crosslinked with resorcinol and paraform, reinforced with inorganic components such as chrysotile microdispersions, micro- and nanodispersions of shungite mineral, and gas black. Oscillation testing identified the optimal additive concentration range of 0.6–0.7 wt%, resulting in a complex modulus increase of up to 25.7%. The most effective polymer-inorganic composite developed by us, incorporating gas black, demonstrates high water shutoff capability (residual resistance factor ranges from 12.5 to 65.0 units within the permeability interval of 151.7 to 10.5 mD). Furthermore, the developed composites exhibit the ability to selectively reduce water permeability disproportionately more than oil permeability. Filtration tests confirmed that the residual permeability to oil after placing the blocking composition with graphene is 6.75 times higher than that to water. Consequently, such treatments reduce the well water cut. Field trials confirmed the effectiveness of the developed polymer-inorganic composite systems.
Polyacrylamide and polyacrylamide/polysaccharide hydrogels exhibiting high structural and mechanical properties, along with acceptable gelation times and gelant viscosity, are proposed for water shutoff applications in high-temperature reservoirs. The obtained polyacrylamide gels demonstrate an elastic modulus 1.6–2.7 times higher than that of the baseline polyacrylamide–resorcinol–paraform–sulfamic acid gel (17.2 Pa), reaching up to 46.3 Pa, while the polyacrylamide/polysaccharide gels surpass it by a factor of 2.3–5.2, reaching up to 89.9 Pa. The gelation time of the polyacrylamide/polysaccharide gels ranges from 3 to 7 h, with the gelant viscosity varying from 685 to 2098 mPa·s at a shear rate of 100 s−1. Crosslinking of polyacrylamide with polysaccharides was achieved using paraform. Using the gel based on crosslinked polyacrylamide with xanthan as an example, spectral methods characterized the copolymer constituting the basis of the plugging material. Our analysis established that crosslinking occurs between the amide group of polyacrylamide and the hydroxyl group of the polysaccharide. Model reactions with low-molecular-weight analogs (glucose, acetamide, and formaldehyde), coupled with mass spectrometric confirmation of the structure of the resulting products, revealed possible reaction pathways. The crosslinking of polyacrylamide was investigated using a broad range of polysaccharides of plant and microbiological origin. The resulting series of hydrogels, possessing the suite of properties required for water shutoff in high-temperature formations, will enable oil companies (operators) and service firms to select a specific gel-forming system based on project objectives, logistics, and budget constraints.