Jin Tao

Mr. Jin Tao

orcid

Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 October 2025 in Coatings
Verified
Journal Article
Open access
PDF file
JLJunan Lu
Junan Lu
LZLei Zha
Lei Zha
YLYong Liu
Yong Liu
KXKaiyun Xu
Kaiyun Xu
JTJin Tao
Jin Tao
Haobo YuHaobo Yu
Haobo Yu
The exploitation of China’s oil and gas resources has advanced into the “ten-thousand-meter” ultra-deep realm. Downhole tubulars and well control equipment materials face severe corrosion challenges under the extreme high-temperature, high-pressure, and highly acidic environments prevalent in such formations. However, the corrosion mechanisms and patterns of materials under these harsh conditions remain insufficiently elucidated, necessitating systematic research. This study focuses on the typical casing material P110SS, investigating its corrosion behavior in high-temperature, high-pressure H2S/CO2 environments. The results show that at a partial pressure of H2S of 0.5 MPa, the corrosion rate of P110SS increases with temperature. A significant increase in the corrosion rate and the occurrence of pitting corrosion were observed between 100 °C and 140 °C. The corrosion product transformed from mackinawite to pyrrhotite. At 60 °C, increasing the partial pressure of H2S led to a slight increase in the corrosion rate, while at 160 °C, the corrosion rate slightly decreased. However, temperature changes did not cause any alteration in the corrosion products.

13 December 2025 in Coatings
Verified
Journal Article
Open access
PDF file
JLJunan Lu
Junan Lu
XZXuliang Zhang
Xuliang Zhang
JCJianglin Chen
Jianglin Chen
TXTianguo Xia
Tianguo Xia
JTJin Tao
Jin Tao
Haobo YuHaobo Yu
Haobo Yu
Rubber is a crucial sealing material in the petroleum industry. Due to increasingly stringent industrial development, safety performance requirements are becoming extremely high, resulting in higher oil resistance requirements for rubber. HNBR exhibits good heat resistance, high tensile strength, tear strength, and excellent wear resistance. However, a certain degree of aging will also occur in the actual service process, which will affect the service life of rubber. In order to explore the factors affecting the aging behavior of HNBR vulcanizates in an oil–water environment at 150 °C, HNBR vulcanizates were aged in an independent environment. IR (Infrared) spectroscopy analysis (FTIR), crosslinking density analysis, dynamic mechanical analysis (DMA), and scanning electron microscopy (SEM) testing were used to characterize the microstructural and morphological changes in HNBR vulcanizates before and after aging. The aging mechanism of HNBR vulcanizates in different environments was obtained. Since factors such as rubber fillers remained constant throughout the experimental process, the influence of formulation variables on aging was disregarded.