In this study, the mechanical machinability of an interpenetrating metal-ceramic composite was investigated. The material was manufactured by gas pressure infiltration of a slurry-based ceramic preform and an AlSi10Mg cast alloy. The combination of a soft metal and a very hard ceramic brings many advantages in mechanical performance of the composite but challenges in the mechanical machining. Near net shape components manufactured and finished by mechanical processing is of interest. Therefore, diamond-grinding with different diamond grit tipped tools was investigated in a range of process parameters, such as the rotation speed, feed rate, and cutting depth. During the grinding process, the cutting forces were continuously measured, and the machined surface and tool quality were evaluated afterwards. Cold welding of the aluminum chips on the tool and the material surface were detected, and the effect of the superposition of ductile and brittle cutting mechanisms were observed. Increasing cutting forces and therefore increasing the process heat results in reclosing of brittle defects in Al2O3 by deformed aluminum. This effect leads to a reduced surface roughness when increasing the material removal rate by increasing cutting speed, feed rate, and cutting depth.
Surface finishing processes are required to produce the final shape of components made of the silicon-infiltrated silicon carbide composite Cesic® from ECM (Engineered Ceramic Materials GmbH, 85452 Moosinning, Germany). Electrical discharge machining (EDM) is still the most effective method for manufacturing pockets and mounts in 3D-shaped ceramic satellite components for space applications. NC-grinding is not used, because it results in high grinding loads and rapid tool wear when applied to Cesic®. In contrast to planar machining, tool wear during NC-grinding with small tools is particularly critical, as it alters the tool geometry and consequently causes deviations in the workpiece geometry. Ultrasonic-assisted grinding offers a promising alternative to overcome the low material removal rates and long processing times associated with EDM while simultaneously enhancing tool life, thus enabling more economical and reliable production. In this experimental study, both conventional grinding (CG) and ultrasonic-assisted grinding (UAG) processes are compared and used to machine Cesic®. In order to verify the effect of the ultrasonic vibration, analyses of amplitude and frequency are performed. During machining experiments, the grinding loads are measured. The influence of different machining conditions on surface quality is evaluated concerning the roughness of the machined specimens. Compared to CG, UAG shows lower tool wear, owing to the self-cleaning effects caused by the ultrasonic oscillation of the tool. Consequently, the stability of the NC-grinding process is significantly improved.