Raman spectroscopy was used to study the time course of phenotypic responses of Escherichia coli (DH5α) to 1-butanol exposure (1.2% [vol/vol]). Raman spectroscopy is of interest for bacterial phenotyping because it can be performed (i) in near real time, (ii) with minimal sample preparation (label-free), and (iii) with minimal spectral interference from water. Traditional off-line analytical methodologies were applied to both 1-butanol-treated and control cells to draw correlations with Raman data. Here, distinct sets of Raman bands are presented that characterize phenotypic traits of E. coli with maximized correlation to off-line measurements. In addition, the observed time course phenotypic responses of E. coli to 1.2% (vol/vol) 1-butanol exposure included the following: (i) decreased saturated fatty acids levels, (ii) retention of unsaturated fatty acids and low levels of cyclopropane fatty acids, (iii) increased membrane fluidity following the initial response of increased rigidity, and (iv) no changes in total protein content or protein-derived amino acid composition. For most phenotypic traits, correlation coefficients between Raman spectroscopy and traditional off-line analytical approaches exceeded 0.75, and major trends were captured. The results suggest that near-real-time Raman spectroscopy is suitable for approximating metabolic and physiological phenotyping of bacterial cells subjected to toxic environmental conditions.
The phenotypic responses of E. coli cells exposed to 1.2% (v/v) of 1-butanol, 2-butanol, isobutanol, tert-butanol, and 1,4-butanediol were studied in near real-time using Raman spectroscopy. A method of “chemometric fingerprinting” was employed that uses multivariate statistics (principal component analysis and linear discriminant analysis) to identify E. coli phenotypic changes over a 180 min post-treatment time-course. A toxicity study showed extreme variability among the reduction in culture growth, with 1-butanol showing the greatest toxicity and 1,4-butanediol showing relatively no toxicity. Chemometric fingerprinting showed distinct phenotype clusters according to the type of alcohol: (i) 1-butanol and 2-butanol (straight chain alcohols); (ii) isobutanol and tert-butanol (branched chain alcohols); and (iii) control and 1,4-butanediol (no terminal alkyl end) treated cells. While the isobutanol and tert-butanol treated cells led to similar phenotypic responses, isobutanol was significantly more toxic. In addition, the phenotypic response was found to take place largely within 60 min of culture treatment; however, significant responses (especially for 1,4-butanediol) were still occurring at 180 min post-treatment. The methodology presented here identified different phenotypic responses to seemingly similar 4-carbon alcohols and can be used to study phenotypic responses of virtually any cell type under any set of environmental conditions or genetic manipulations.
Clostridium acetobutylicum has traditionally been used for production of acetone, butanol, and ethanol (ABE). Butanol is a commodity chemical due in part to its suitability as a biofuel; however, the current yield of this product from biological systems is not economically feasible as an alternative fuel source. Understanding solvent phase physiology, solvent tolerance, and their genetic underpinning is key for future strain optimization of the bacterium. This study shows the importance of a [NiFe]-hydrogenase in solvent phase physiology. C. acetobutylicum genes ca_c0810 and ca_c0811, annotated as a HypF and HypD maturation factor, were found to be required for [NiFe]-hydrogenase activity. They were shown to be part of a polycistronic operon with other hyp genes. Hydrogenase activity assays of the ΔhypF/hypD mutant showed an almost complete inactivation of the [NiFe]-hydrogenase. Metabolic studies comparing ΔhypF/hypD and wild type (WT) strains in planktonic and sessile conditions indicated the hydrogenase was important for solvent phase metabolism. For the mutant, reabsorption of acetate and butyrate was inhibited during solventogenesis in planktonic cultures, and less ABE was produced. During sessile growth, the ΔhypF/hypD mutant had higher initial acetone: butanol ratios, which is consistent with the inability to obtain reduced cofactors via H2 uptake. In sessile conditions, the ΔhypF/hypD mutant was inhibited in early solventogenesis, but it appeared to remodel its metabolism and produced mainly butanol in late solventogenesis without the uptake of acids. Energy filtered transmission electron microscopy (EFTEM) mapped Pd(II) reduction via [NiFe]-hydrogenase induced H2 oxidation at the extracelluar side of the membrane on WT cells. A decrease of Pd(0) deposits on ΔhypF/hypD comparatively to WT indicates that the [NiFe]-hydrogenase contributed to the Pd(II) reduction. Calculations of reaction potentials during acidogenesis and solventogenesis predict the [NiFe]-hydrogenase can couple NAD+ reduction with membrane transport of electrons. Extracellular oxidation of H2 combined with the potential for electron transport across the membrane indicate that the [NiFe}-hydrogenase contributes to proton motive force maintenance via hydrogen cycling.