Polyvinylpyrrolidone/hexagonal boron nitride (PVP/hBN) composite nanofibers were produced by the electrospinning method at 4, 6, and 8 wt% concentration of hBN in an effort to examine the effects of defect distribution and density on the nonlinear absorption and optical limiting behavior. Open aperture (OA) Z-scan experiments were performed at 1064, 532 and 355 nm under various input intensities. While scanning electron microscopy revealed homogeneous and cylindrical nanofibers for each composition, the average diameter of the cylindrical nanofibers decreased from 349 nm to 296 nm with increasing hBN concentration. The linear absorption results showed an increase in the defect states and distribution in the energy band gap with the addition of hBN. All composite nanofibers have a positive nonlinear absorption (NA) signal and decrease with increasing input density at 1064 and 532 nm due to the filling effect of defect states with one photon absorption (OPA). While an increase in βeff and ISAT values is obtained with increasing hBN concentration at all excitation wavelengths, a more pronounced NA behavior is observed at 1064 nm. OPA is the dominant mechanism due to the defect distribution inside the band gap of PVP at 1064 nm with significant contribution from sequential and simultaneous two photon absorption. Although similar NA mechanisms occurred at 532 and 355 nm, excited state absorption from defect states of PVP to defect states of hBN in the band gap led to higher nonlinear absorption behavior compared to 532 nm. The lower onset optical limiting threshold was obtained to be 0.58 mJ cm−2 at 1064 nm for PVP nanofibers with 8 wt% of hBN. The broad absorption spectrum, strong NA behavior and low limiting threshold properties make PVP/hBN composite nanofibers good candidates as effective optical limiters in a wide spectral region.
17 January 2019 in Journal of Applied Polymer Science
To enhance the optical limiting behavior triggered by nonlinear absorption (NA), wide-band gap MnO2 nanoparticles were incorporated into polyvinylpyrrolidone (PVP) polymer nanofibers at various concentrations. SEM images of the composite nanofibers showed that MnO2 nanoparticles are well entrapped in the nanofibers. With an increase in MnO2 nanofiller concentration, a widened optical band gap energy and an increased Urbach energy were observed. As the concentration of MnO2 nanofiller in PVP increased, the NA behavior became more pronounced but weakened with higher input intensity. This behavior was attributed to the filling of the localized defect states by one photon absorption (OPA). The NA mechanisms of the composite nanofibers were examined, considering their band gap energies and localized defect states. Although all of the composite nanofibers had OPA, sequential/simultaneous two photon absorption (TPA), and excited state absorption mechanisms, the higher concentration of the MnO2 nanofiller led to stronger NA behavior due to its more defective structure. The highest optical limiting behavior was observed for composite nanofibers with the highest concentration of MnO2 nanofiller. The results obtained show that these composite nanofibers with a high linear transmittance and an extended band gap energy can be used in optoelectronic applications that can operate in a wide spectral range. Furthermore, their robust NA behavior, coupled with their promising optical limiting characteristics, positions them as strong contenders for effective optical limiting applications.