Quantitative prediction of the early‐summer warm‐sector heavy rainfall over South China coast (SCC) is still a challenge. This study conducts convection‐permitting Weather Research and Forecast model simulations for a representative nocturnal‐to‐morning heavy rainfall event related to low‐level jets during 29–30 May 2020, and explores sources of simulated rainfall bias using multi‐source observations, reanalysis data and sensitivity experiments. Results show that the model initiated about 12 hr before the coastal convection initiation only produces sporadic convection and misses the heavy rainfall at SCC, although it captures the major synoptic features as in previous studies. The underestimated convection development is closely related to insufficient convergence of boundary layer (BL) wind due to overestimated speed of the onshore BL wind. Increasing the land surface friction effects in the simulations through either multiplying the surface roughness length by 10 or including sub‐grid topography drag effects could help little suppress the simulated biases. Using hourly data assimilation to improve the simulation of marine/land BL temperature from the afternoon to nighttime produces a desired change in the nocturnal BL wind across the coastline and significantly improves rainfall simulation with the maximum and average rainfall over SCC increased by about 4 and 6.5 times, respectively. These findings indicate that, to improve the prediction of the nocturnal heavy rainfall in the warm‐sector over SCC during early summer, it is necessary to more accurately predict the BL thermal structure during the daytime, in addition to the previously emphasized nocturnally enhanced marine BL flow.
The data assimilation method to improve the sea fog forecast over the Yellow Sea is usually three-dimensional variational assimilation (3DVAR), whereas ensemble Kalman filter (EnKF) has not yet been applied to this weather phenomenon. In this paper, two sea fog cases over the Yellow sea, one spread widely and the other spread narrowly along the coastal area, are studied in detail by a series of numerical experiments with 3DVAR and EnKF based on the Grid-point Statistical Interpolation (GSI) system and the Weather Research and Forecasting (WRF) model. The results show that the assimilation effect of EnKF outperforms that of 3DVAR: for the widespread-fog case, the probability of detection and equitable threat scores of the forecasted sea fog area are improved respectively by ~57.9% and ~55.5%; the sea fog formation of the other case completely mis-forecasted by 3DVAR was produced successfully by EnKF. These improvements of EnKF relative to 3DVAR benefit from its flow-dependent background error covariances, resulting in more realistic depiction of sea surface wind for the widespread-fog case and better moisture distribution for the other case in the initial conditions. More importantly, the correlation between temperature and humidity in the background error covariances of EnKF plays a vital role in the response of moisture to the assimilation of temperature, which leads to a great improvement in the initial moisture conditions for sea fog forecast. Extra sensitivity experiments of EnKF indicate that the forecast result is sensitive to ensemble inflation and localization factors, in particular, highly sensitive to the latter.
16 July 2021 in Journal of Geophysical Research: Atmospheres
A series of convection‐permitting numerical experiments using the Weather Research and Forecasting Model with different model configurations are performed to investigate physical mechanisms governing convection initiation (CI) at the coast of South China (SC) during a warm‐sector heavy rainfall event occurred before the South China Sea (SCS) monsoon onset. The simulation results are more sensitive to initial state from the different reanalysis products than the microphysics schemes, horizontal resolutions, initialization time, and lateral boundary conditions with the variation examined. It is found that the speeds of easterly to southeasterly winds in the boundary layer (BL) over northern SCS determine the strength of horizontal convergence of the warm and moist airflows arriving at the coast. The mid‐tropospheric divergence over the west coastal areas of SC and its southwest upstream impact vertical motion of the mid‐to‐lower tropospheric southwesterly airflows when approaching the coast. Differences in such features of upstream airflows in the experiments lead to distinct temporal evolutions of BL dynamic lifting and temperature stratification in the mid‐to‐lower levels at the CI location, thus the level of free convection and convective available potential energy. The modeling evidence presented shows that the synoptic dynamic and thermodynamic characteristics of the upstream airflows in BL and mid‐to‐lower troposphere, with local modulation by the coastal mountains, play important roles in determining the time and location of CI, and the distribution and amount of rainfall. Studies on more cases are needed to gain more general and robust conclusions about physical mechanism governing the warm‐sector coastal CI.
Numerical modeling of sea fog is highly sensitive to initial conditions, especially to moisture in the marine atmospheric boundary layer (MABL). Data assimilation plays a vital role in the improvement of initial MABL moisture for sea fog modeling over the Yellow Sea. In this study, the weather research and forecasting (WRF) model and its three-dimensional variational (3DVAR) data assimilation module are employed for sea fog simulations. Two kinds of background error (BE) covariances with different control variables (CV) used in WRF-3DVAR, that is, CV5 and multivariate BE (CV6), are compared in detail by explorative case studies and a series of application experiments. Statistical verification metrics including probability of detection (POD) and equitable threat scores (ETS) of forecasted sea fog area are computed and compared for simulations with the implementations of CV5 and CV6 in the WRF-3DVAR system. The following is found: (1) there exists a dominant negative correlation between temperature and moisture in CV6 near the sea surface, which makes it possible to improve the initial moisture condition in the MABL by assimilation of observed temperature; (2) in general, the performance of the WRF-3DVAR assimilation with CV6 is distinctly better, and the results of 10 additional sea fog cases clearly suggest that CV6 is more suitable than CV5 for sea fog modeling. Compared to those with CV5, the average POD and ETS of forecasted sea fog area using 3DVAR with CV6 can be improved by 27.6% and 21.0%, respectively.
Based on high-resolution surface observation and reanalysis data, this paper analyzes the extreme heat events (EHEs) over two densely populated urban agglomerations in southeast China, namely the Yangtze River Delta (YRD) and the Pearl River Delta (PRD), including the spatial–temporal distribution of heatwaves and warm nights and the synoptic backgrounds for regional heatwaves. The results show that the occurrence frequency of EHEs is modulated significantly by local underlying features (i.e., land–sea contrast, terrain), and the strong nocturnal urban heat island effects make warm nights much more likely to occur in cities than rural areas during heatwaves. About 80% of the YRD regional heatwaves occur from 15 July to 15 August, while a lower fraction (53%) of the PRD heatwaves is found during this mid-summer period, which partially explains the warm-season average intensity of the former being 2–3 times the latter. A persistent, profound subtropical high is the dominant synoptic system responsible for the mid-summer YRD heatwaves, which forces significant descending motion leading to long-duration sunny weather. The mid-summer PRD heatwaves involve both high-pressure systems and tropical cyclones (TCs). A TC is present to the east of the PRD region on most (about 72%) PRD heatwave days. The organized northerly winds in the planetary boundary layer in the outer circulation of the TC transport the inland warm air, which is heated by the foehn effect at the lee side of the Nanling Mountains and possibly also the surface sensible heat flux, towards the PRD region, leading to the occurrence of the extremely high temperatures.
4 January 2024 in Journal of Geophysical Research: Atmospheres