To address the high computational cost and significant resource consumption of radar Doppler-based target recognition, which limits its application in real-time embedded systems, this paper proposes a lightweight CNN (Convolutional Neural Network) approach for radar target identification. The proposed approach builds a deep convolutional neural network using range-Doppler maps, and leverages data collected by frequency-modulated continuous wave (FMCW) radar from targets such as drones, vehicles, and pedestrians. This method enables efficient object detection and classification across a wide range of scenarios. To improve the performance of the proposed model, this study incorporates a coordinate attention mechanism within the convolutional neural network. This mechanism fine-tunes the network’s focus by dynamically adjusting the weights of different feature channels and spatial regions, allowing it to concentrate on the most informative areas. Experimental results show that the foundational architecture of the proposed deep learning model, RangDopplerNet Type-1, effectively captures micro-Doppler features from range-Doppler maps across diverse targets. This capability enables precise detection and classification, with the model achieving an impressive average recognition accuracy of 96.71%. The enhanced network architecture, RangeDopplerNet Type-2, reached an average accuracy of 98.08%, while retaining a compact footprint of only 403 KB. Compared with standard lightweight models such as MobileNetV2, the proposed architecture reduces model size by 97.04%. This demonstrates that, while improving accuracy, the proposed architecture also significantly reduces both computational and storage overhead.The deep learning model introduced in this study is specifically tailored for deployment on resource-constrained platforms, including mobile and embedded systems. It provides an efficient and practical approach for development of miniaturized low-power devices.

In this work, we propose a localization method based on an exogenous radar with multi-base station and the synchronization signal block (SSB) in 5G downlink signals. We combine physical cell identities (PCIs)-based identification with the extensive cancellation algorithm (ECA) to reconstruct and cancel the present strongest SSB signal, thereby obtaining reference signal receiving power (RSRP) values of them in descending order of strength. Then, we designed a two-stage localization method. Firstly, we determined the target’s coarse location based on the directional characteristics of different SSB beams. Subsequently, we compared the RSRP values extracted from the actually received signals against those pre-obtained when the target is at various reference points. The reference point corresponding to the closest match was selected as the estimated target position. We conducted simulations under various signal-to-noise ratio (SNR) levels, reference point densities, and signal jitter conditions. The simulation results demonstrate that the method outperforms techniques such as Fang’s method for time difference of arrival (Fang-TDOA) and observed time difference of arrival (OTDOA).