Shaped tube electrolytic drilling (STED) is an electrochemical machining variant that employs a tubular tool electrode to produce holes with a high aspect ratio on hard-to-machine materials. The tubular electrodes with a diameter below 1 mm produce undesired residue (center-peak) at the machining surface that hampers the machining rate. Therefore, this study attempts to improve the electrolyte flow and enhance the electrochemical dissolution through tool modification. The performance enhancement of the STED process in terms of material removal rate and average diametral overcut has been explored. The issues related to the limitations in material removal in the STED process are brought forth with the technique to resolve those difficulties. The experiments were conducted with the modified tubular tool, and the length of slits on the tool was selected based on the simulation insights and pilot study. The effects of input process parameters (applied voltage, tool feed rate, electrolyte concentration, and tool slit length) on the output responses obtained from the STED process are elaborated. Holes with diameters in the range 0.89–0.97 mm and 12 mm depth were fabricated. Further optimization of the process parameters in the design space is also presented to obtain sustainable process performance.
13 December 2025 in The International Journal of Advanced Manufacturing Technology
The rotary tool micro-ultrasonic machining (RT-MUSM) process is a newly developed variant of conventional micro-USM. It is preferred over conventional micro-USM due to its ability to remove material at a faster rate and with better accuracy than the machined microfeatures. Some experimental investigations have been conducted on the RT-MUSM process for the machining of hard and brittle materials. However, the theoretical model of the material removal rate (MRR) for the RT-MUSM process has not been discussed in the literature. Thus, the present research work reports on developing a predictive model of the MRR for the RT-MUSM process during glass machining. Pure brittle fracture mode was considered to be the material removal mechanism during the model's development. The developed model was verified through experiments. The estimated results were compared with the experimental results and found to be in good agreement with each other. Additionally, statistical analysis was carried out for the prediction accuracy of the developed model. The results revealed that the model is adequate, with a correlation coefficient of 0.9976 and a mean absolute percentage error of 2.45%. Hence, the developed model can be used to estimate the MRR for the RT-MUSM process of hard and brittle materials such as ceramics.