This study investigates the flow field and temperature field characteristics of a certain type of aerospace tail-thrust clutch friction plate under engagement conditions. A thermo–fluid–solid coupled convective heat transfer model was established based on the velocity distribution of lubricating oil within the groove cavities. The model was applied to analyze the surface temperature distribution of a single friction pair (friction plate and steel plate) under different operating parameters. The results reveal that both the inlet temperature and flow rate of the lubricating oil have a mitigating effect on temperature rise. However, due to the geometric constraints of the groove structure, the maximum wetted area and the actual inflow are inherently limited. Consequently, the temperature evolution during engagement is more significantly influenced by rotational speed and applied pressure. In particular, once these parameters exceed certain critical values, the surface temperature exhibits a sharp increase. Furthermore, the optimization of lubricating flow is constrained by friction materials. A higher flow rate does not necessarily yield greater lubrication benefits; instead, the optimal flow rate solution tailored to the friction pair should be pursued. This work provides theoretical insights into parameter control for aerospace tail-thrust clutches in practical operation.

This study examines the strongly nonlinear cross-media dynamics of a deep-sea umbilical cable–payload system during free-surface crossing under different sea states and lifting speeds. A two-dimensional time-domain lumped-mass model was established, in which the cable was discretized into node–axial elements. Morison-type hydrodynamic loading, added mass, and a continuous air–water parameter transition governed by an immersion factor were included for both the cable and the lower-end payload. To improve numerical robustness in long-duration simulations, a segmented ODE15s integration scheme was adopted, together with a smooth-start lifting–heave boundary condition and an adaptive lift-height correction procedure to ensure a stable cross-media response window. The results show a clear spatially segmented response: the upper cable remains nearly straight, whereas the middle and lower sections accommodate most of the lateral offset and curvature redistribution, which intensify under stronger environmental forcing. Top tension shows a gradually increasing mean component superimposed on quasi-periodic oscillations, while bottom tension, detrended vertical payload displacement, and vertical hydrodynamic force are more sensitive to sea-state severity and lifting speed. These results provide a comparative numerical basis for identifying response trends, screening lifting speed options, and interpreting cross-media load transfer mechanisms. Because the formulation is two-dimensional and has not yet been validated against model-scale or full-scale measurements, the results should not be interpreted as equipment-specific safety limits.