High-quality single-crystal diamond films, homoepitaxially grown by microwave chemical vapor deposition, have been used to produce diamond-based photodetectors. Such devices were tested over a very wide spectral range, from the extreme ultraviolet (UV) (20 nm) up to the near IR region (2400 nm). An optical parametric oscillator tunable laser was used to investigate the 210–2400 nm spectral range in pulse mode. In this region, the spectral response shows a UV to visible contrast of about 6 orders of magnitude. A time response shorter than 5 ns, i.e., the laser pulse duration, was observed. By integrating the pulse shape, a minor slow component was evidenced, which can be explained in terms of trapping–detrapping effects. Extreme UV gas sources and a toroidal grating vacuum monochromator were used to measure the device response down to 20 nm in continuous mode. In particular, the extreme UV He spectrum was measured and the He II m, 30.4 nmand He I 58.4 nm emission lines were clearly detected. The measured time response of 0.2 s is totally due to the instrumental readout time constants. In both experimental setups an extremely good stability and reproducibility of the device response were obtained, whereas no persistent photoconductivity nor undesirable pumping effects were observed.

Recently, solid state photovoltaic Schottky diodes, able to detect ionizing radiation, in particular, x-ray and ultraviolet radiation, have been developed at the University of Rome “Tor Vergata.” We report on a physical and electrical properties analysis of the device and a detailed study of its detection capabilities as determined by its electrical properties. The design of the device is based on a metal/nominally intrinsic/p-type diamond layered structure obtained by microwave plasma chemical vapor deposition of homoepitaxial single crystal diamond followed by thermal evaporation of a metallic contact. The device can operate in an unbiased mode by using the built-in potential arising from the electrode-diamond junction. We compare the expected response of the device to photons of various energies calculated through Monte Carlo simulation with experimental data collected in a well controlled experimental setup i.e., monochromatic high flux x-ray beams from 6 to 20 keV, available at the Diamond Light Source synchrotron in Harwell (U.K.).