This study reports on experiments concerning the boundary shear stress and boundary shear force distributions in a smooth rectangular flume. Nonlinear regression-based equations are derived from experimental analysis to give the percentage of the total shear force carried by the walls and mean wall and bed shear stresses around the wetted perimeter as functions of the ratio of channel width to channel depth.Key words: boundary shear, shear force, open channel flow.
Dynamic programming with successive approximation has been used in the past for optimizing multi-reservoir water resources systems. In this study, the State Incremental Dynamic Programming (SIDP) model is developed for energy optimization of multi-reservoir systems. A random file access method is used for reaching initial and intermediate data to cope with the curse of dimensionality of dynamic programming. A conventional dynamic programming method is used for each single reservoir to find the initial trajectory of the reservoirs. Then, the computer program developed in the study is applied to the multipurpose-multi-reservoir system in Lower Seyhan Basin, which has six reservoirs, some of which are serial and some parallel. First, extended historical flows were used to maximize firm energy in the critical period, and then total energy in the total flows. The program was run with 50-year long segments (20 flow scenarios) of the synthetic flow data generated by using the HEC-4 generalized computer program to take into account the stochastic nature of stream flows. An increment of approximately 20 percent in total energy was obtained by using the model for the Lower Seyhan System, as compared to that calculated previously by conventional methods.
The U.S. Federal Highway Administration (FHA) method for computing bridge backwater was modified on the basis of significantly large prototype data (Neely 1966; Bradley 1978). Both the water surface profile and the backwater amount given by the original FHA method, which was developed after extensive laboratory model studies, differed appreciably from those recorded on natural reaches around highway bridges. Although a satisfactory explanation for this discrepancy was not given, most of the design charts of the FHA method were modified according to the prototype data (Bradley 1978). Here, a clear-cut explanation is given, and a modification for the bridge subroutine of the commonly used package program HEC-2 is suggested.