Coal nanopore structure is an important factor in understanding the storage and migration of absorbed gas in coal. A new method for studying coal nanopore structures is proposed. This idea is based on the nano-level resolution of atomic force microscopy, which can be employed to observe the structural features of coal nanopores clearly, conduct quantitative three-dimensional measurements and obtain structural parameters. Analysis results show that coal nanopores are mainly metamorphic pores and intermolecular pores. The metamorphic pores are commonly rounded and elliptical, increasing quantitatively with the coalification degree. The forms of intermolecular pores change markedly. The average pore size of low-rank coal is bigger than high-rank coal, and the number of intermolecular pores decreases as the coal rank increases. Section analysis effectively characterizes the coal pore microstructure, bearing analysis is a vital approach to measure microporosity, and grain analysis can be employed to study the pore size distribution. Atomic force microscopy is a tool for the in-depth research of coal pore microstructure and the coal-bed methane adsorption mechanism.
A series of coals of varying rank, from brown coal to anthracite, were studied by Fourier transform infrared spectroscopy (FTIR). Curve-fitting analysis was employed to characterize coal structural evolution during the coalification process. The study was carried out on samples of a natural evolutionary series as well as experimental simulation coals dispersed on KBr pellets throughout the Ordos Basin, China. The results showed that the infrared spectrum of coal allowed quality and even quantity identification of the degree of coalification. Oxygen-containing groups and alkyl side chains of coal cracked at different rates with increasing degree of coalification. The cracking rates were divided into three stages according to the main changes in coal structure. These stages were carboxyl groups, fat groups and aromatic rings. Carboxyl groups decreased when Ro was less than 0.5%, and these groups were maintained until the fat coal stage began. Fat groups mainly cracked at the asphaltization stage and formed abundant hydrocarbons. These groups were the main sources for the formation of immature and low maturity, coal-generating oil before asphaltization. In the high evolutionary stage, after asphaltization, all alkyl side chains in the coal had cracked, while the degree of condensed aromatic rings had increased greatly. The ratios of aromatic hydrocarbons (3000 to 3100 cm−1) to aliphatic carbons (2800 to 3000 cm−1), CH2/CH3 (2920/2950 cm−1) and carboxyl groups to aromatic carbons (1705/1620 cm−1 + 1600cm−1 + 1580 cm−1) appeared to be suitable parameters for assessing the natural maturation of coal.