Laser-directed energy deposition (DED) using wire or powder feedstock is a promising way to fabricate prototypes in rapid time, including complex metal parts for advanced engineering applications. In this work, AISI 316L stainless steel—a well-known, weldable alloy model—was used to perform a foundational comparative study of wire-fed (LW-DED) and powder-fed (LP-DED) processes, establishing a baseline before progressing to high-temperature alloys. Hollow cylindrical specimens were fabricated and characterized microstructurally and mechanically. LP-DED produced a refined cellular–dendritic structure with primary dendrite arm spacing of 3.29 ± 0.49 µm and slightly higher average hardness (226 ± 8 HV0.2), accompanied by fine, spherical porosity inherent to the powder feedstock. LW-DED generated coarser epitaxial columnar dendrites (5.15 ± 0.69 µm) and slightly lower hardness (206 ± 10 HV0.2) but achieved nearly full density and high material catching efficiency. The results indicate that both methods yield comparable deposits when parameters are controlled, with LP-DED offering enhanced microstructural refinement and LW-DED providing faster deposition and higher build volume. These findings provide practical guidance for the additive manufacturing of high-performance parts and establish a baseline for the application of DED processes to advanced alloys.
This research reveals the anti-friction and anti-wear performance of lubricants using a castor oil base and a deep eutectic solvent (DES1) as an additive. To this end, DES1 was synthesized in a successful manner using DL-menthol and dodecanoic acid as components. Mass concentrations from 0.1 wt% up to 5 wt% of DES1 additives were chosen to formulate the lubricants. Friction experiments were conducted, yielding friction enhancements up to 4% compared to the castor oil base. Notably the greatest reduction was achieved for the lubricant with 0.1 wt% of DES1. In terms of the wear generated, the best anti-wear performance was achieved for the 0.5 wt% DES1 lubricant (with a wear reduction of 17%). Furthermore, by means of the profilometry of worn surfaces, it can be observed that the tribofilm formation of DES1 on steel surfaces is a potential lubrication mechanism.