Microplastic pollution and its impact on the ecological environment have attracted worldwide attention. The strong adsorption capacity of the microplastic surface plays an important role in the migration of microplastics throughout the environment. Synergistic effects between microplastics and persistent organic pollutants increase the toxicity of pollutants to organisms. In addition, microplastics cause different degrees of harm to aquatic organisms with different nutritional levels. However, the toxic effects of microplastics and organic pollutants on organisms, the distribution of microplastics in higher aquatic organisms, and the nutrient transfer in complex aquatic food webs require further research. Therefore, studying the impact of microplastics on the ecological environment would provide insights into controlling microplastic pollution. This paper in-depth discusses the source, distribution, and transmission of microplastics and summarizes the current situation of the impact of microplastics on the ecological environment, including physical, chemical, and biological effects. This paper also suggests topics for further research on the influence of microplastics on various aspects of the ecological environment.
This paper presented results of a numerical study on seven designs of T shape fishways. The trajectory equation of the maximum velocity line and the V/Va equation of the T shape fishways were obtained from the results. It was found that a width of 1.5bs for the T lateral baffle, a width of 5bs and a length of 6.25bs for the pools were very satisfactory for the dimensional design of T shape fishways, where bs was the slot width. From the seven designs studied, design 3 (D3, D denotes “design”) was recommended for practical use.
31 December 2021 in Stavební obzor - Civil Engineering Journal
Nature-like fishway arrangements are commonly used because these structures imitate the characteristics of natural rivers and effectively allow fish to migrate past river sections blocked by hydraulic structures. In this paper, physical models were analyzed, and the velocity distributions of two different fishway structures (Types I and II) were compared. Results showed that the maximum mainstream velocity of the Type I structure was 5.3% lower than that of the Type II structure. However, the average mainstream velocity of the Type I structure was 21.1% greater than that of the Type II structure. The total per-cycle length of the mainstream path in the Type II structure was 2.1 times greater than that of the Type I structure, which indicated that the length of the mainstream path was somewhat proportional to the average velocity of the mainstream. When the flow rate was kept constant, increases in the velocity of the main flow associated with changes in the internal structure of the fishway decreased the average velocity of the main flow, while decreases in the total length of the flow path led to increases in the average velocity of the main flow. Due to frictional head loss along the fishway and local head loss, as well as the overlaps between these factors, the overall flow rate gradually decreased every cycle, despite periodic fluctuations.