For an impact drop on a superheated surface, the dynamic Leidenfrost temperature, TLF, depends on several parameters such as impact velocity, vapor layer thickness, and thermophysical properties of the fluids. In this letter, we derived a scaling formula for TLF using the well-known balance relation between the pressures exerted by drop impact and evaporated vapor flow. As the TLF scale intrinsically requires estimating the vapor film thickness δv, it should be scaled based on the consideration of relevant physics postulated on the impact drop and evaporated vapor. Thus, for proper scaling of δv, we considered the drop–vapor interface deformation by drop inertial and surface tension forces during initial impact of drop. Results showed that δv could be scaled with drop diameter D0 and Weber number We. For drops with low We (<10), δv scaled to ∼D0We−1/4 and ∼D0We−2/5 for drops with higher We. The explicit scale for TLF agreed well with present experimental data.
A boiling crisis, or critical heat flux (CHF), is a condition that determines the upper bound on removable thermal energy at a boiling surface. In such situations, the liquid cannot wet the surface because a vapor film completely covers it. CHF is enhanced on micro-structured surfaces when under boiling conditions. CHF values were measured for surfaces with rectangular microchannel geometries of various channel widths, (10–30 μm) and generally increased in value as channel widths decreased. However, the CHF value for the 5-μm channel-width surface was found to be lower than the wider channel-width surfaces. This observation contradicts models based on vapor recoil and classical instability mechanisms. Hence, we present a fluid-dynamics model that considers capillary pumping and viscous friction. With a focus on the spatial distribution of the liquid penetration region and the local dry spot under a large vapor bubble, this model can accurately predict the CHF variation associated with different channel widths.
The dynamic Leidenfrost phenomenon is governed by three types of pressure potentials induced via vapor hydrodynamics, liquid dynamic pressure, and the water hammer effect resulting from the generation of acoustic waves at the liquid-vapor interface. The prediction of the Leidenfrost temperature for a dynamic droplet needs quantitative evaluation and definition for each of the pressure fields. In particular, the textures on a heated surface can significantly affect the vapor hydrodynamics and the water hammer pressure. We present a quantitative model for evaluating the water hammer pressure on micro-textured surfaces taking into account the absorption of acoustic waves into the thin vapor layer. The model demonstrates that the strength of the acoustic flow into the liquid droplet, which directly contributes to the water hammer pressure, depends on the magnitude of the acoustic resistance (impedance) in the droplet and the vapor region. In consequence, the micro-textures of the surface and the increased spacing between them reduce the water hammer coefficient ( ) defined as the ratio of the acoustic flow into the droplet to total generated flow. Aided by numerical calculations that solve the laminar Navier-Stokes equation for the vapor flow, we also predict the dynamic Leidenfrost temperature on a micro-textured surface with reliable accuracy consistent with the experimental data.
1 April 2021 in International Journal of Heat and Mass Transfer