Evanescent field excitation is a powerful means to achieve a high surface-to-bulk signal ratio for bioimaging and sensing applications. However, standard evanescent wave techniques such as TIRF and SNOM require complex microscopy setups. Additionally, the precise positioning of the source relative to the analytes of interest is required, as the evanescent wave is critically distance-dependent. In this work, we present a detailed investigation of evanescent field excitation of near-surface waveguides written using femtosecond laser in glass. We studied the waveguide-to-surface distance and refractive index change to attain a high coupling efficiency between evanescent waves and organic fluorophores. First, our study demonstrated a reduction in sensing efficiency for waveguides written at their minimum distance to the surface without ablation as the refractive index contrast of the waveguide increased. While this result was anticipated, it had not been previously demonstrated in the literature. Moreover, we found that fluorescence excitation by waveguides can be enhanced using plasmonic silver nanoparticles. The nanoparticles were also organized in linear assemblies, perpendicular to the waveguide, with a wrinkled PDMS stamp technique, which resulted in an excitation enhancement of over 20 times compared to the setup without nanoparticles.

One third of fatal car accidents and so many tragedies are due to alcohol abuse. These sad numbers could be mitigated if everyone had access to a breathalyzer anytime and anywhere. Having a breathalyzer built into a phone or wearable technology could be the way to get around reluctance to carry a separate device. With this goal, we propose an inexpensive breathalyzer that could be integrated in the screens of mobile devices. Our technology is based on the evaporation rate of the fog produced by the breath on the phone screen, which increases with increasing breath alcohol content. The device simply uses a photodiode placed on the side of the screen to measure the signature of the scattered light intensity from the phone display that is guided through the stress layer of the Gorilla glass screen. A part of the display light is coupled to the stress layer via the evanescent field induced at the edge of the breath microdroplets. We demonstrate that the intensity signature measured at the detector can be linked to blood alcohol content. We fabricated a prototype in a smartphone case powered by the phone’s battery, controlled by an application installed on the smartphone, and tested it in real-world environments. Limitations and future work toward a fully operational device are discussed.

Ultrafast mid-infrared fiber lasers have been intensely studied in the last decade for the generation of high harmonics, molecular spectroscopy, material processing and remote sensing. Different designs have been investigated but most of them lacked the ease of use and reliability needed for their democratization. In this paper, we demonstrate a self-starting mode-locked mid-IR erbium-doped fiber laser based on a SESAM and a broadband uniform FBG that produces pulses as short as 15 ps. Different laser cavities were tested with varying FBG peak reflectance, spectral bandwidth and active fiber length. In addition, one cavity uses a pump combiner instead of injecting free-space the pump power through the fiber tip. The results of this study confirm that the FBG spectral bandwidth can efficiently control the duration of the almost Fourier-transform-limited pulses up to a limit seemingly dictated by the presence of water vapor in the laser cavity acting as narrow spectral filters. To a lower effect, the active fiber length influences the pulse duration. Finally, the use of an all-fiber pump combiner allows for a more compact and rugged design without altering the laser performances. This study represents a step towards the development of robust mid-infrared ultrafast all-fiber lasers.

We report the first fiber-based mid-IR supercontinuum extending up to 8 µm generated in a low-loss commercial step index As₂Se₃ fiber.

A highly efficient and high power Raman fiber laser was developed based on the use of broadband Fiber Bragg gratings as optical couplers. The broadening of the Stokes signal is analyzed in both cases where the laser emission is restricted or not by the FBGs bandwidth. Since broadband fiber Bragg gratings are involved, the effects of cladding mode losses have to be considered. In order to reduce overall losses in the cavity, an optimal cavity configuration has been determined based on the physical orientation of the fiber Bragg gratings.