This letter presents a mechanically reconfigurable metasurface (MRM) designed to operate in the n257 FR2 5G band with the ability to provide a reconfigurable beam splitting. The MRM unit cell consists of a metallic rod with a metallic cone-shaped element at its end. The actuator is an electromagnet that provides 1-bit reconfiguration by modifying the position of the cone-shaped element. A prototype is experimentally assessed. The measurements reveal a phase shift of 180o$\pm$ 30o from 26.5 GHz to 29.5 GHz. Several beam configurations for the MRM have been measured where the scattering patterns show good agreement with the simulations. To demonstrate the potential of the proposed MRM, an indoor field trial has been performed. In a novel way, a simultaneously coverage of two different indoor zones has been achieved with an improvement of more than 10.9 dB of received average power.
Global data consumption is experiencing exponential growth, driving the demand for wireless links with higher transmission speeds, lower latency, and support for emerging applications such as 6G. A promising approach to address these requirements is the use of higher-frequency bands, which in turn necessitates the development of advanced antenna systems. This work presents the design and experimental validation of a reconfigurable, low-cost leaky-wave antenna capable of controlling the propagation direction of single-, dual-, and triple-beam configurations in the FR3 frequency band. The antenna employs slotted periodic patterns to enable directional electromagnetic field leakage, and it is based on a cost-effective and simple 3D-printing fabrication process. Laboratory testing confirms the theoretical and simulated predictions, demonstrating the feasibility of the proposed antenna solution.
6 March 2026 in Computers and Electrical Engineering
This paper presents the design, fabrication and experimental validation of a mechanically reconfigurable 2-bit unit cell for reconfigurable intelligent surface (RIS). The unit cell design is based on the controlled displacement of a metalized moving element inside a parallelplate waveguide. A compact stepper micromotor is used to enable precise individual phase reflection reconfiguration of each RIS unit cell. The proposed unit cell achieves a phase shift between states of 90º ± 20º , with a reflection losses below 1.09 dB across the entire n258 FR2 band of 5G (24.25 GHz-27.5 GHz). A prototype composed of a 15 × 15 unit cells has been fabricated using high-precision stereolithography (SLA) 3-D printing followed by an low-cost aerosol metallization process. A beam steering up to ±40 o is achieved under normal incidence and up to ±50 o for an oblique incidence of 20 o , with a cross-polarization level difference grater than 32dB. The RCS gain in the main beam direction remains above 46 dB across the entire target band and beam steering scenarios. At 26 GHz, the maximum RCS gain reaches 57.1 dB.
Reconfigurable intelligent surfaces (RISs) are expected to be key enablers of wireless communications systems in the fifth-generation (5G) and beyond. These electromagnetic devices offer significant flexibility, enabling both coverage enhancement in blind spots and real-time user tracking through dynamic beamforming. Current state-of-art research primarily focuses on RIS design and validation at sub-6 GHz frequencies. In this work, we evaluate the suitability of a RIS design at 28 GHz band for improving the total coverage within a realworld propagation indoor environment. After a thorough analysis of aspects such as path loss or multipath components, we found that the optimal RIS configuration contributes to a rich multipath environment which increases spatial coverage exceeding 90%. Therefore, this study demonstrates that the proposed RIS design is appropriate to assist millimeter wave communications within a laboratory room scenario in non line-of-sight conditions.