Corn processing generates thousands of tons of cob husks, which still contains many valuable elements. To make the most of these wastes, they are applied as substrates for biotransformation's procedures. This approach allowed converting or releasing, the elements deposited in the plant material and obtaining valuable products. Thus bioconversion of corn cob husks (CCH) using a fungus of the Fusarium culmorum genus resulted in obtaining silica nanoparticles of defined size and morphology. SEM analysis excluded their presence on the surface of the substrate. FTIR confirmed the presence of siloxane bonds and O-Si-O bonds in post-biotransformation fluid. Using the Heteropoly Blue Method, it was checked that the highest concentration of silica during 16-day biotransformation falls on the 7th day of the process, in which both the substrate sterilization and the process of the biocatalyst starvation were of key importance. Using the STEM and EDX analysis, it was proved that the obtained nanoparticles with a spherical form are structured and their dimensions are ~40 and ~70 nm. ICP-OES proved that the overall process efficiency was 47%. Such nanoparticles can be successfully used in the medical industry.

In the present study, a comprehensive approach to the biosorption process was proposed. Biosorption of Cr(III), Mn(II) and Mg(II) ions by a freshwater macroalga Cladophora glomerata was examined using several advanced techniques including FTIR (Fourier Transform Infrared Spectroscopy), ICP-OES (Inductively Coupled Plasma–Optical Emission Spectrometry) and SEM-EDX (Scanning Electron Microscopy with Energy Dispersive X-Ray Spectroscopy). The enriched biomass can become a valuable, bioactive feed additive for different breeds of animals. Additionally, the collected algal biomass was soaked in water in order to reduce the content of carbohydrate, what is especially important for animals with metabolic disorders. The content of starch was reduced by 22% but additionally some elements–mainly Si, K and P were removed from the biomass. It was shown that the natural macroalga had better biosorption properties than soaked. Cr(III) ions were sorbed by the biomass in the highest extent, then Mn(II) and finally Mg(II) ions. The content of chromium in the enriched algal biomass increased almost ~200 000 times, manganese ~75 times and magnesium ~4.5 times (both for Mg(II) ions used from magnesium sulphate, as well as from magnesium chloride) when compared to the natural Cladophora glomerata. In the case of the soaked biomass the increase of the content of elements in the enriched biomass was as follows ~17 165 times for Cr, ~25 times for Mn and for Mg ~3.5 times for chloride and 3.8 times for sulphate. The type of magnesium salt (chloride or sulphate) had no significant effect on the algal sorption capacity. The proposed mechanism of the biosorption is ion exchange in which mainly potassium participated. The applied FTIR analysis enabled the identification of the functional groups that participated in the biosorption process–mainly carboxyl and hydroxyl. The main changes in the appearance of the spectra were observed for the following wavenumbers– 3300–3400; 2900; 1700; 1400–1500 and 1200–1300 cm^-1. The application of SEM-EDX proved that the metal ions were sorbed on the surface of both tested algae.

In this work, a method of recalculation of results of X-ray fluorescence (XRF) technique to Inductively Coupled Plasma-Optical Emission Spectroscopy (ICP-OES) method was elaborated for biosorption studies. Equations that calibrate XRF to ICP-OES were determined, as a biosorbent strawberry, blackcurrant and raspberry seeds after supercritical CO₂ extraction were used. ICP-OES showed a better precision and lower detection limits than XRF. The latter technique is cheaper, requires minimal sample preparation and gives faster results. Linear regression of the data gave almost 1:1 correlations without additional correction (for Cu r² = 0.9998, Mn r² = 0.807, Zn r² = 0.979). Calibration and quantification of intensities of XRF was obtained using ICP-OES measurements after samples digestion with HNO₃ in a microwave system. High positive correlations were estimated for Cu, Mn, Zn. It was demonstrated that XRF technique can be used together with other well established techniques (ICP-OES) to produce quantitative data from biosorption studies. Elaboration of cheap and quick analytical methodology is an important aspect in development of new processes and products based on biosorption process.