This study proposes an optimization approach for ship spare parts allocation by integrating the ideal point method (IPM) with an improved ant colony algorithm. The traditional R/C (Reliability–Cost Ratio) model is constrained by single-objective formulations that fail to reconcile cost efficiency with system reliability, often producing the paradoxical result that fewer spare parts correspond to higher reliability. To address this limitation, a multi-objective model was constructed for reliability–cost optimization, while the enhanced ant colony algorithm identifies optimal spare part configurations that achieve balanced trade-offs. Nine representative scenarios were analyzed, with simulation outcomes compared between the IPM and R/C model approaches. Sensitivity analyses of critical parameters were conducted, and the effectiveness of both approaches was evaluated. The results demonstrate that the IPM consistently achieves higher reliability, particularly under stringent reliability requirements and tighter spare parts constraints. The findings provide a robust analytical foundation for evidence-based decision-making in ship equipment support.
An optimization method for the spare parts configuration of marine equipment is investigated based on spare parts support probability and utilization rate indicators. First, a general expression for the spare parts utilization rate is presented, and analytical expressions for the spare parts support probability and utilization rate are derived for Gamma-type spare parts with non-exponential life distributions, which are commonly found in marine spare parts. The relationship between two calculation methods for the utilization rate of exponential-type spare parts, as a special case of Gamma-type spare parts, is discussed. Second, as the analytical expression for the Gamma-type spare parts utilization rate is relatively complex, an approximate calculation method for the spare parts utilization rate is provided. Under the condition of given support probability requirements, the spare parts utilization rate is calculated through three approaches: theoretical calculation, approximate calculation, and simulation experiment. The calculation results demonstrate the validity of the analytical expression for the spare parts utilization rate and the applicability of the approximate algorithm. Furthermore, an approximate algorithm for the Weibull-type spare parts utilization rate is presented and verified through simulation calculations. Subsequently, considering both spare parts support probability requirements and utilization rate requirements, a spare parts configuration optimization model is established with the objective of maximizing the cost ratio, and the calculation procedures are provided. Finally, the feasibility of the spare parts configuration optimization model is illustrated through case analysis.