The oxidation of glycerol under alkaline conditions in the presence of a heterogeneous catalyst can be tailored to the formation of lactic acid, an important commodity chemical. Despite recent advances in this area, the mechanism for its formation is still a subject of contention. In this study, we use a model 1 wt. % AuPt/TiO2 catalyst to probe this mechanism by conducting a series of isotopic labeling experiments with 1,3-13C glycerol. Optimization of the reaction conditions was first conducted to ensure high selectivity to lactic acid in the isotopic labeling experiments. Selectivity to lactic acid increased with temperature and concentration of NaOH, but increasing the O2 pressure appeared to influence only the rate of reaction. Using 1,3-13C glycerol, we demonstrate that conversion of pyruvaldehyde to lactic acid proceeds via a base-promoted 1,2-hydride shift. There was no evidence to suggest that this occurs via a 2,1-methide shift under the conditions used in this study.
6 January 2023 in Physical Chemistry Chemical Physics
We investigate the effect of chlorides on the photocatalytic degradation of phenol by titania polymorphs (anatase and rutile). We demonstrate how solubilised chlorides can affect the hydroxyl radical formation on both polymorphs with an overall effect on their photodegradative activity. Initially, the photocatalytic activity of anatase and rutile for phenol degradation is investigated in both standard water and brines. With anatase, a significant reduction of the phenol conversion rate is observed (from a pseudo-first-order rate constant k = 5.3 x 10-3 min-1 to k = 3.5 x 10-3 min-1). In contrast, the presence of solubilised chlorides results in enhancement of rutile activity under the same reaction conditions (from 2.3 x 10-3 min-1 to 4.8 x 10-3 min-1). Periodic DFT methods are extensively employed and we show that after the generation of charge separation in the modelled titania systems, adsorbed chlorides are the preferential site for partial hole localisation, although small energy differences are computed between partially localised hole densities over adsorbed chloride or hydroxyl. Moreover, chlorides can reduce or inhibit the ability of r-TiO2 (110) and a-TiO2 (101) systems to localise polarons in the slab structure. These results indicate that both mechanisms – hole scavenging and the inhibition of hole localisation - can be the origin of the effect of chlorides on photocatalytic activity of both titania polymorphs. These results provide fundamental insight into the photocatalytic properties of titania polymorphs and elucidate the effect of adsorbed anions over radical formation and oxidative decomposition of organic pollutants.
In this study, we examine autoxidation and its role on the catalytic aerobic oxidation of cinnamyl alcohol using supported AuPd nanoparticles. We further report the crucial role of reaction conditions in the reaction pathway. Close attention is paid to the mechanism of the formation of benzaldehyde, a by-product formed in large quantities from the process of autoxidation. The activity of the catalysts depends on the preparation method with different sizes of nanoparticles obtained by the two methods of preparation. The catalysts can inhibit the autoxidation process or the two processes, namely catalytic oxidation and autoxidation, can coexist. In the case of oxidation of cinnamyl alcohol, 0.5%(wt) Au–0.5%(wt) Pd/TiO2 catalysts prepared by various methods allow different product distributions to be obtained. The catalyst prepared by the sol-immobilisation method seems to prevent autoxidation, leaving the catalytic process dominant. Catalysts prepared by the impregnation method seem to enable both the catalytic process and autoxidation to occur at the same time. We show that using the optimum catalyst for this reaction, the autoxidation process can be mitigated.
The solar-driven reduction of nitrate to nitrogen has been studied in the presence of a formate hole scavenger, over a series of Au- and Ag-decorated TiO 2 catalysts.
The selectivity and activity of gold-catalysts supported on graphite and graphene have been compared in the oxidation of cyclohexene. These catalysts were prepared via impregnation and sol immobilisation methods, and tested using solventless and radical initiator-free reaction conditions. The selectivity of these catalysts has been directed towards cyclohexene epoxide using WO3 as a co-catalyst and further to cyclohexane diol by the addition of water, achieving a maximum selectivity of 17% to the diol. The sol immobilisation catalysts were more reproducible and far more active, however, selectivity towards the diol was lower than for the impregnation catalyst. The results suggest that formation of cyclohexane diol through solventless oxidation of cyclohexene is limited by a number of factors, such as the formation of an allylic hydroperoxyl species as well as the amount of in situ generated water.