A part of the system CaO-SiO2–Al2O3–Fe2O3–MgO which is of relevance to iron-ore sintering has been studied in detail. For a bulk composition corresponding to 10.45 wt% CaO, 5.49 wt% MgO, 69.15 wt% Fe2O3, 13.37 wt% Al2O3and 1.55 wt% SiO2synthesis runs have been performed in air in the range between 1100 and 1300°C. Products have been characterized using reflected-light microscopy, electron microprobe analysis and diffraction techniques. At 1250°C, an almost phase-pure material with composition Ca2.99Mg2.67Fe3+14.58Fe2+0.77Al4.56Si0.43O36has been obtained. The compound corresponds to the first Si-containing representative of theM14+6nO20+8npolysomatic series of so-called SFCA phases (Silico-Ferrites ofCalcium andAluminum) withn= 2 and is denoted as SFCA-III. Single-crystal diffraction investigations using synchrotron radiation at the X06DA beamline of the Swiss Light Source revealed that the chemically homogenous sample contained both a triclinic and monoclinic polytype. Basic crystallographic data are as follows: triclinic form:a= 10.3279 (2) Å,b= 10.4340 (2) Å,c= 14.3794 (2) Å, α = 93.4888 (12)°, β = 107.3209 (14)° and γ = 109.6626 (14)°,V= 1370.49 (5) Å3,Z= 2, space group P{\overline 1}; monoclinic form:a= 10.3277 (2) Å,b= 27.0134 (4) Å,c= 10.4344 (2) Å, β = 109.668 (2)°,V= 2741.22 (9) Å3,Z= 4, space groupP21/n. Structure determination of both modifications was successful using diffraction data from the same allotwinned crystal. A description of the observed polytypism within the framework of OD-theory is presented. Triclinic and monoclinic SFCA-III actually correspond to the two possible maximum degree of order structures based on OD-layers containing three spinel (S) and one pyroxene (P) modules (〈S3P〉). The existence of SFCA-III in industrial iron-ore sinters has yet to be confirmed. Polytypism is likely to occur in other SFCA-members (SFCA, SFCA-I) relevant to sintering as well, but has so far been neglected in the characterization of industrial samples. Our results shed light on this phenomenon and may therefore be also helpful for better interpretation of the powder diffraction patterns that are used for phase analysis of iron-ore sinters.
17 February 2006 in Journal of Physics: Condensed Matter
NASICON-based solid electrolytes with exceptionally high Na-ion conductivities are considered to enable future all solid-state Na-ion battery technologies. Despite forty years of research the interrelation between crystal structure and Na-ion conduction is still controversially discussed and far from being fully understood. In this study microcontact impedance spectroscopy combined with single crystal X-ray diffraction, and differential scanning calorimetry is applied to tackle the question how bulk Na-ion conductivity σbulk of sub-mm-sized flux grown Na3Sc2(PO4)3 (NSP) single crystals is influenced by supposed phase changes (α, β, and γ phase) discussed in literature. Although we found a smooth structural change at around 140 °C, which we assign to the β→γ phase transition, our conductivity data follows a single Arrhenius law from room temperature up to 220 °C. Obviously, the structural change, being mainly related to decreasing Na-ion ordering with increasing temperature do not cause any jumps in ion conductivity or any discontinuities in activation energies Ea. Bulk ion dynamics in NSP have so far rarely been documented; here, under ambient conditions σbulk turned out to be as high as 3 × 10−4 S cm−1 (Ea, bulk = 0.39 eV) when directly measured with microcontacts for individual small single crystals.