Heterogeneous grain structures may develop due to abnormal grain growth during processing of polycrystalline materials ranging from metals and alloys to ceramics. The phenomenon must be controlled in practical applications where typically homogeneous grain structures are desired. Recent advances in experimental and computational techniques have, thus, stimulated the need to revisit the underlying growth mechanisms. Here, phase field modelling is used to systematically evaluate conditions for initiation of abnormal grain growth. Grain boundaries are classified into two classes, i.e., high- and low-mobility boundaries. Three different approaches are considered for having high- and low-mobility boundaries: (i) critical threshold angle of grain boundary disorientation above which boundaries are highly mobile, (ii) two grain types A and B with the A–B boundaries being highly mobile, and (iii) three grain types, A, B and C with the A–B boundaries being fast. For these different scenarios, 2D simulations have been performed to quantify the effect of variations in the mobility ratio, threshold angle and fractions of grain types, respectively, on the potential onset of abnormal grain growth and the degree of heterogeneity in the resulting grain structures. The required mobility ratios to observe abnormal grain growth are quantified as a function of the fraction of high-mobility boundaries. The scenario with three grain types (A, B, C) has been identified as one that promotes strongly irregular abnormal grains including island grains, as observed experimentally.
The austenite-ferrite transformation is the key metallurgical tool to tailor properties of low alloyed steels and remains an active area of research. Models have yet to be developed with truly predictive capabilities for phase transformations in multi-component commercial steels. This review provides a critical analysis of the various austenite-to-ferrite diffusional transformation model approaches that have been significantly broadened over the past decade by modelling at different length scales, i.e. classical macro-scale models have been augmented with simulations at the meso-scale and atomistic scale. Both semi-empirical and fundamental models are reviewed with an emphasis on polygonal ferrite formation in low and medium carbon steels. Formation of ferrite with more complex morphologies (i.e. irregular/bainitic/Widmanstätten ferrite) is also discussed. In particular, approaches to describe the interaction of alloying elements with the austenite-ferrite interface are critically analysed. The paper concludes with an outlook on the proposed austenite-ferrite transformation modelling work for the next decade.
An important aspect of the integrity of oil and gas pipelines is the heat-affected zone (HAZ) of girth welds where the microstructure of the as-hot rolled steel is altered with potentially adverse effects on the HAZ properties. Therefore, it is critical to evaluate the HAZ microstructure for different welding scenarios. Here, an integrated microstructure evolution model is proposed and applied to the HAZ of an X80 linepipe steel. The model considers dissolution of Nb-rich precipitates, austenite grain growth and austenite decomposition into ferrite and bainite. Microstructure maps showing the fraction of transformation products as a function of distance from the fusion line are obtained and used to compare the effect of different welding procedures on the HAZ microstructure.