Osteochondral tissue damage is a serious concern, with even minor cartilage damage dramatically increasing an individual's risk of osteoarthritis. Therefore, there is a need for an early intervention for osteochondral tissue regeneration. 3D printing is an exciting method for developing novel scaffolds, especially for creating biological scaffolds for osteochondral tissue engineering. However, many 3D printing techniques rely on creating a lattice structure, which often demonstrates poor cell bridging between filaments due to its large pore size, reducing regenerative speed and capacity. To tackle this issue, a novel biphasic scaffold was developed by a combination of 3D printed poly(ethylene glycol)-terephthalate-poly(butylene-terephthalate) (PEGT/PBT) lattice infilled with a porous silk scaffold (derived from Bombyx mori silk fibroin) to make up a bone phase, which continued to a seamless silk top layer, representing a cartilage phase. Compression testing showed scaffolds had Young's modulus, ultimate compressive strength, and fatigue resistance that would allow for their theoretical survival during implantation and joint articulation without stress-shielding mechanosensitive cells. Fluorescent microscopy showed biphasic scaffolds could support the attachment and spreading of human mesenchymal stem cells from bone marrow (hMSC-BM). These promising results highlight the potential utilization of this novel scaffold for osteochondral tissue regeneration as well as highlighting the potential of infilling silk materials within 3D printed scaffolds to further increase their versatility.
Non-textile application of silk fiber is the major focus of the present scientific communities. Characteristics, i.e., structural, mechanical, are the key advantages of silk protein to make it promising candidates for its variable application. Keeping this in view, the present investigation has been conducted to understand the structural and mechanical variability of silk breeds, i.e., CSR2 × CSR4 (single hybrid), PM × CSR2 (cross breed) and FC1 × FC2 (double hybrid) for their respective promising non-textile application. It is envisaged that FC1 × FC2 (double hybrid) has the highest tensile strength (431.47 ± 28.46 MPa), Young’s modulus (5.92 ± 0.45 GPa) and β-sheet content (46.62 ± 1.45%). The lowest nano-crystallite size (3.34 ± 0.22) and elongation % (10.85 ± 0.77) were also observed in the FC1 × FC2. Further, significant positive correlation was observed between β-sheet with crystalline % (p *** < 0.001; r = 0.95), crystalline % with tensile strength (p *** < 0.001; r = 0.91) and Young’s modulus with tensile strength (p * < 0.001; r = 0.80). This indicates that the higher the β-sheet content is, the higher the tensile strength and higher crystalline phase of the fiber will be. Crystallite size has a negative correlation with the β-sheet content, crystalline %, tensile strength and Young’s modulus, which shows that the lower the crystallite size, the more the compactness and strength will be.