This study presents a systematic methodological review supported by a scientometric approach on the use of electrical conductivity (EC) to assess the pozzolanic activity of supplementary cementitious materials (SCMs). The increasing demand for sustainable alternatives to Portland cement has intensified the development of new SCMs, reinforcing the need for rapid and reliable methods to evaluate their reactivity. Electrical conductivity-based tests have gained attention due to their simplicity, low cost, and sensitivity to ionic variations during pozzolanic reactions; however, their methodological consistency and interpretative robustness remain debated. A total of 103 articles published between 1989 and 2025 were systematically selected from the Scopus and Web of Science databases. Scientometric analyses were employed to characterize the temporal evolution of the field, its main contributors, journals, collaboration networks, and influential documents. In parallel, the 20 most cited studies were examined in depth to identify experimental parameters, testing configurations, and data treatment strategies. Multivariate analyses, including Principal Component Analysis and Multiple Correspondence Analysis, were applied to reveal recurrent quantitative and qualitative methodological patterns. The results indicate sustained growth in scientific production, combined with pronounced heterogeneity in EC testing protocols. This variability helps explain recurrent inconsistencies reported in the literature, particularly discrepancies with mechanical performance, limitations of blank correction procedures, uncertainties regarding reaction mechanisms, and atypical conductivity behavior under high calcium hydroxide contents. Overall, EC is confirmed as a valuable tool for rapid screening and early-stage assessment, although its use as a standalone indicator of pozzolanic activity remains limited.
31 December 2018 in Revista de Engenharia e Pesquisa Aplicada
Este trabalho tem como objetivo identificar e descrever as manifestações patológicas existentes nas obras de contenção de terra armada em quatro viadutos de duas rodovias da Região Metropolitana do Recife, a PE-15 e a PE-22. As obras da PE-15, foram construídas para Copa do Mundo de 2014 e já apresentam diversos problemas causados pela falta de manutenção, além dos erros construtivos. A contenção da PE-22 foi inaugurada em 2003 e apresenta problemas mais graves do que as contenções da PE-15. Se os problemas identificados durante as inspeções, não forem corrigidos com brevidade, poderão gerar grandes custos em intervenções de recuperação e até em acidentes, caso haja grande demora nas correções. Ao final deste trabalho são feitas conclusões e apresentadas recomendações para melhorar a conservação, o desempenho e a vida útil dos muros de terra armada.
16 September 2026 in ENCONTRO NACIONAL DE TECNOLOGIA DO AMBIENTE CONSTRUÍDO
The construction industry requires sustainable solutions to reduce the consumption of natural resources and promote the reuse of waste materials. In this context, this study evaluated the mechanical performance of rendering mortars with volumetric replacement of natural sand by 0%, 5%, 10%, and 15% PET. Compressive strength and flexural tensile strength were evaluated after 7, 14, 28, and 56 days of curing, while tensile bond strength was evaluated after 28 days. At 56 days, the mortar containing 15% PET exhibited compressive and flexural tensile strengths approximately 34% and 18% higher than those of the reference mortar, respectively, whereas tensile bond strength decreased by approximately 42%. Under the evaluated conditions, PET incorporation increased the mechanical strengths at 56 days, although it reduced tensile bond strength.
The UPV technique has been widely employed to predict the hardened properties of Portland cement mixtures. This article assesses the hardened properties of alkali-activated blast furnace slag mortars by comparing UPV measurements with compressive strength and dry density and calculating the dynamic modulus of elasticity from UPV results. The mixtures were prepared varying the type of activator (sodium metasilicate and sodium silicate), the content of Na2O in the activators (3.0, 4.5, 6.0, and 7.5%), and the water/binder ratio. The results showed that exponential models showed medium and high determination coefficients (R2), which explained the correlation between UPV and hardened properties. It was observed a limitation on the measurements of UPV, which did not surpass 4.4 km/s, which made it difficult to predict compressive strength value above 50 MPa. The dynamic modulus of elasticity calculated from UPV showed reliable results, even varying the Poisson’s coefficient between 0.15 and 0.25. Lastly, it was also observed that a correlation between the content of C-S-H and UPV suggested that this technique can also be used to predict the evolution of the hydration products in alkali-activated slag mixtures.