Cooling analysis with the boundary element method (BEM) forms full-matrix equations in injection molding. Computers have no ability to handle it when the element number is more than its acceptance. This paper adopts the elements incorporation method. It changes the original model from one large matrix equation to one small union matrix equation and several small block matrix equations. In this way, the calculation time is shortened considerably and the treatable number of element in cooling analysis is enhanced dramatically. In-mold labeling processing, which adds a label on part surface in the mold is a new technology, and it is becoming more and more popular. It affords the mold designer far greater latitude in the design of graphics, part shape, and the use of multiple molded components in a single molded unit. Its simulation is a new task in computer aided engineering (CAE). This paper is based on the feature that the cavity surface is always meshed into planar triangular elements, Supposing that the label and part are two plates with perfect contact, establishes a one dimensional unsteady heat transfer model under the first dissymmetry boundary for each element. Using this heat transfer model, the cooling analysis model of in-mold labeling is established.
22 May 2007 in Polymer-Plastics Technology and Engineering
Cooling system in injection molding is of great importance because it cannot only reduce molding cycle time efficiently but also can improve part quality. Current cooling analysis method is based on boundary element method (BEM). Because the cooling analysis module is so complex, with the same BEM, the equations of the item calculation of coefficient matrix are variable. Different calculation equations cause different problems, which influence its practicability. This article presents a practicable analysis model. Many tests show its result is reasonable.
25 March 2019 in Modelling and Simulation in Materials Science and Engineering
Both fast solving speed and high accuracy are the goals of polymers' crystal numerical simulation including the calculation of crystallinity and morphology on the mesoscale (10-3-10-6 m). In our previous work, the stereological Delesse law was applied to improve the solving speed of the crystal simulation algorithm, in which the pixel coloring method and Monte Carlo method were used. However, the new algorithm is imperfect and likely to cause some errors because the idea of statistical average is implicitly included in the Delesse law. This work is to expand the algorithm's scope with another stereological principle, named Rosiwal law, and quantitatively discuss the errors' magnitude, influence factors and changing trends when the two stereological principles are employed. The calculation results illustrate that the relative error caused by stereological law is gradually self-reducing, while a big absolute error probably appeared when the very limited cross section or line is used at some middle time steps. Our results will offer some guidelines on the choice of sections and lines in fast crystal simulation algorithm and its software development.