Synthesizing a broad scope of peropyrenes and teropyrenes with tunable bandgaps is now possible via an InCl ₃ -catalyzed one-pot multifold alkyne benzannulation reaction.

The copper corrosion was studied for 30 days in two alkaline electrolytes: saturated Ca(OH)₂ and cement extract, employed to simulate concrete-pore environments. Electrochemical Impedance Spectroscopy (EIS) and Cyclic Voltammetry were carried out at the open circuit potential (OCP), and potentiodynamic polarization (PDP) curves were performed for comparative purposes. Electrochemical current fluctuations, considered as electrochemical noise (EN), were employed as non-destructive methods. The tests revealed that sat. Ca(OH)₂ is the less aggressive to the Cu surface, mainly because of the lower in one order pH. In consequence, the OCP values of Cu were more positive, the polarization resistance values were higher by one order of magnitude, and the anodic currents of Cu were lower than those in the cement extract. The analyzed EN indicated that the initial corrosion attacks on the Cu surface are quasi-uniform, resulting from the stationary persistent corrosion process occurring in both model solutions. XPS analysis and X-ray diffraction (XRD) patterns revealed that in sat. Ca(OH)₂, a Cu₂O/CuO corrosion layer was formed, which effectively protects the metallic Cu-surface. We present evidence for the sequential oxidation of Cu to the (+1) and (+2) species, its impact on the corrosion layer, and also its protective properties.

We report the stochastic interactions between dye sensitized anatase nanoparticles, suspended in a colloid, and a Pt ultramicroelectrode (UME) that result in step-wise behavior in the current vs. time response. The stochastic currents are observed in the dark and under illumination. In the dark, the currents are anodic, consistent with the oxidation of the dye N719 at the Pt surface. The electrochemical behavior of the dye was investigated in MeOH and MeCN with a quasireversible cyclic voltammogram (CV) observed at 1 V s⁻¹. The anodic currents observed in the dark due to nanoparticles (NPs) at the Pt surface are consistent with the CVs in MeOH and MeCN. Under illumination cathodic steps are observed and assigned to the reduction of the oxidized form of the dye generated after electrons are injected into the TiO₂ NPs. The colloidal behavior is a strong function of the history of the colloid with illumination time increasing the size of the agglomerates and with larger agglomerates being less photoelectrochemically active. Agglomerates of ca. 100 nm in diameter are proposed to be photoactive entities with a higher probability of detection that contribute to the staircase photocurrent response.

We discuss the electrodeposition of two-dimensional (2D) Pt-nanostructures on Highly Oriented Pyrolytic Graphite (HOPG) achieved under constant applied potential versus a Pt counter electrode (E_appl = ca. −2.2 V vs. NHE, normal hydrogen electrode). The deposition conditions are discussed in terms of the electrochemical behavior of the electrodeposition precursor (H₂PtCl₆). We performed cyclic voltammetry (CV) of the electrochemical Pt deposit on HOPG and on Pt substrates to study the relevant phenomena that affect the morphology of Pt deposition. Under conditions where the Pt deposition occurs and H₂ evolution is occurring at the diffusion-limited rate (−0.3 V vs. NHE), Pt forms larger structures on the surface of HOPG, and the electrodeposition of Pt is not limited by diffusion. This indicates the need for large overpotentials to direct the 2D growth of Pt. Investigation of the possible effect of Cl⁻ showed that Cl⁻ deposits on the surface of Pt at low overpotentials, but strips from the surface at potentials more positive than the electrodeposition potential. The CV of Pt on HOPG is a strong function of the nature of the surface. We propose that during immersion of HOPG in the electrodeposition solution (3 mM H₂PtCl₆, 0.5 M NaCl, pH 2.3) Pt islands are formed spontaneously, and these islands drive the growth of the 2D nanostructures. The reducing agents for the spontaneous deposition of Pt from solution are proposed as step edges that get oxidized in the solution. We discuss the possible oxidation reactions for the edge sites.