Phototherapeutics has shown promise in treating various diseases without surgical or drug interventions. However, it is challenging to use it in inner-body applications due to the limited light penetration depth through the skin. Therefore, we propose an organic light-emitting diode (OLED) catheter as an effective photobiomodulation (PBM) platform useful for tubular organs such as duodenums. A fully encapsulated highly flexible OLED is mounted over a round columnar structure, producing axially uniform illumination without local hotspots. The biocompatible and airtight OLED catheter can operate in aqueous environments for extended periods, meeting the essential requirements for inner-body medical applications. In a diabetic Goto-Kakizaki (GK) rat model, the red OLED catheter delivering 798 mJ of energy is shown to reduce hyperglycemia and insulin resistance compared to the sham group. Results are further supported by the subdued liver fibrosis, illustrating the immense potential of the OLED-catheter–based internal PBM for the treatment of type 2 diabetes and other diseases yet to be identified.
Stretchable organic light-emitting diodes (OLEDs) have emerged as promising optoelectronic devices with exceptional degree of freedom in form factors. However, stretching OLEDs often results in a reduction in the geometrical fill factor (FF), that is the ratio of an active area to the total area, thereby limiting their potential for a broad range of applications. To overcome these challenges, we propose a three-dimensional (3D) architecture adopting a hidden active area that serves a dual role as both an emitting area and an interconnector. For this purpose, an ultrathin OLED is first attached to a 3D rigid island array structure through quadaxial stretching for precise, deformation-free alignment. A portion of the ultrathin OLED is concealed by letting it ‘fold in’ between the adjacent islands in the initial, non-stretched condition and gradually surfaces to the top upon stretching. This design enables the proposed stretchable OLEDs to exhibit a relatively high FF not only in the initial state but also after substantial deformation corresponding to a 30% biaxial system strain. Moreover, passive-matrix OLED displays that utilize this architecture are shown to be configurable for compensation of post-stretch resolution loss, demonstrating the efficacy of the proposed approach in realizing the full potential of stretchable OLEDs.
Microdisplay is a key technology for realizing augmented reality (AR) and mixed reality (MR) devices, which have attracted much attention of late. Even though the operating voltage in the tandem structure is higher than that in the single structure, 2-stack tandem OLED exhibited 20,000 cd/m2 at 9 V, which is compatible with CMOS circuit driving. Due to its top-emitting geometry with a tandem structure, the OLED device with a well-controlled thickness exhibited a white spectrum with (0.26, 0.26) color coordinates. The pixel density of the fabricated microdisplay panel with a white tandem OLED was about 2350 pixels per inch, and the active area of the panel was 0.7 inch diagonally. The resolution of the panel was 1280 × 1024, corresponding to SXGA, and the maximal luminance was 3,000 cd/m2.
13 November 2019 in Journal of Information Display
From the very first time that graphene was used as a transparent electrode for OLED applications, the emergence of active-matrix (AM)-graphene OLED displays has been envisioned. Realizing this expectation, however, turned out to be difficult. Two obstacles are the growth and transfer of a large-area graphene film and the patterning of a graphene film into pixels. To solve these problems, a process of patterning a graphene film without surface contamination was developed. The fabrication of OLED panels by the patterned graphene anode on Gen 2(370 × 470 mm)-sized and flexible substrates was successfully demonstrated. In this work, oxide TFT arrays were combined as a switching backplane, and a pixelated graphene OLED was used as an emissive layer, to realize AM-graphene OLED displays. To explore the technical feasibility of flexible AM-graphene OLED displays, the aforementioned components were formed on a flexible substrate. For commercial-level production, all the processes that were used were chosen to be compatible with the conventional display processes.
Microdisplays based on organic light-emitting diodes (OLEDs) have a small form factor, and this can be a great advantage when applied to augmented reality and virtual reality devices. In addition, a ...