For determining of the micro-structural changes taking place in a near eutectic Al-Si-Cu aluminium cast alloy during heating and cooling process the UMSA device (Universal Metallurgical Simulator and Analyzer) was used. In this work the dependence between the regulated cooling speed and structure on the basis of the thermo-analysis was carried out. The thermal analysis was performed at a cooling rate in a range of 0,2 °C to 1,25 °C. The changes were examined and evaluated qualitatively by optical and electron scanning microscopy methods and the EDS microanalysis. During the investigation the formation of aluminium reach (α-Al) dendrites was revealed and also the occurrence of the α+β eutectic, the ternary eutectic α+Al2Cu+β, as well a iron and manganese containing phase was confirmed. The performed investigation are discussed for the reason of an possible improvement of thermal and structural properties of the alloy. The achieved results can be used for liquid metal processing in science and industry – for example foundry for developing and obtaining of a required alloy microstructure and properties influenced by a proper production conditions.

In this study, the change of the cooling rate in the range of about 0.1–1 °C s⁻¹ and the addition of Sr on the crystallization kinetics of the cast zinc alloys of the ZnAlCu type, as well as its relation to the microstructure were also investigated. Therefore, the aim of the rapid crystallisation is the achievement of materials with better properties, which can be obtained by refinement of the dendritic or eutectic microstructure, elimination of segregation, or creation of metastable phases and their morphology changes. In the investigated alloys, the change of cooling rate of 1 °C s⁻¹ has caused microstructure’s refinement as well as increase in hardness. Increase in the cooling rate causes also morphology changes of the η + α eutectic, and makes generally a global overcooling of the alloy as well as change in the temperatures at the beginning of crystallization T _DN and of the alloy crystallization T _S. The presented investigations concerning the electron microscopy methods, including transmission electron microscopy, allow revealing the crystallographic structure, based on the d-spacing changes, as well as the diffraction method used for phase determination, which is a helpful tool for the explanation of the important points in the thermo-derivative analysis curve, where the relation between the amount of phase and the occurrence of new phases can be determined.

Although Zn alloys are a very widely used material, there is a need for investigations concerning the influence of thermal conditions on its microstructure and its properties, which makes it useful for the specific tasks it has to fulfil for mass-produced items manufactured by the metalworking industry, in the automotive industry, as well as in countless electronic components. One of the possibilities is to create finer microstructures and enhance their properties, to change their chemical composition by adding alloying additives, and inoculation using modifiers. So in this paper, investigation results are presented concerning the influence of chosen alloying additives, such as Sr, Ce and Ti–B on the measured and calculated thermal characteristics and microstructure of zinc alloys with the addition of aluminium and copper. Based on the results on the phase and chemical composition of the cast Zn–Al–Cu alloys, inoculated with Sr and Ti–B, no differences were detected in the phase composition of the investigated alloys, owing to changes in cooling rates, which were chosen for the sample cooling process. A small amount of added cerium caused the occurrence of new phases present in the microstructure. Modification of the Zn–Al–Cu alloy precipitates changes in the thermomorphology of the phase and the ‘tweed’ type changes in the microstructure. Moreover, the addition of cerium causes a decrease in the temperature at the beginning ( ) and the end of the solidification, as well as the occurrence of a multicomponent eutectic, which can be detected on the derivative curve.