Most reported fluorescent Al³⁺ probes rely on fluorescence signal enhancement or quenching. Since the change in fluorescence intensity is the sole detection signal, various factors such as instrumental efficiency, environmental conditions, and probe concentration can interfere with the signal output. In contrast, ratiometric probes, which utilize two emission bands for self-calibration, provide significant advantages by minimizing or eliminating these uncertainties. In this study, a naphthalimide-rhodamine based the transition between the cyclic and open-ring forms of rhodamine as an Al³⁺-selective ratiometric probe, in which chitosan was identified as an ideal bridge and biocompatibility. The design concept was that when the target metal ion was present, the fluorescence intensity of naphthalimide remained largely unchanged, serving as an internal standard. In contrast, rhodamine B was employed to label the target molecules, with its fluorescence intensity varying in accordance with the target concentration. A series of experiments were carried out to investigate the fluorometric properties of the grafted polymer P. The results demonstrated that P exhibited selective interaction with Al³⁺ among the various metals tested. Using the fluorescence intensity ratio (I_{603 nm}/I_{538 nm}) of P, a good linear relationship was achieved for Al³⁺ concentrations ranging from 1.0 to 35.0 μM with a detection limit of 0.33 μM was obtained. Meanwhile, we employed the standard addition method for the quantitative analysis and detection of Al³⁺ in commercially available bottled water and tap water, achieving an ideal recovery rate.

Chitosan is non-toxic, harmless, biocompatible, and antimicrobial, and can be readily modified. These properties have made it widely used in carrier research. Based on this, a fluorescent probe P was synthesized in high yield from naphthalimide derivatives and carboxymethyl chitosan (CMCS). The probe exhibited enhanced fluorescence in the presence of Al³⁺ and quenched fluorescence in the presence of Mg²⁺ in different media. Among common metal ions and anions, the probe demonstrated good selectivity and sensitivity toward Al³⁺ and Mg²⁺. Under optimal conditions (ethanol–water solution, 1:9, v:v, pH 6.0, 20 mM HEPES), a significant linear relationship was observed for Al³⁺ in the concentration range of 0–90 µM. In ethanol, the fluorescence intensity of the probe at 427 nm decreased regularly with increasing Mg²⁺ concentration, also showing a clear linear relationship within the 5–90 µM range.