Cansu Colak

Mrs. Cansu Colak

orcid

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 June 2023
Verified
Book Chapter
Closed access
PDF file
CCCansu Colak
Cansu Colak
OSOzkan Sengul
Ozkan Sengul

1 December 2025 in Journal of Composites Science
Verified
Journal Article
Open access
PDF file
CCCansu Colak
Cansu Colak
OSOzkan Sengul
Ozkan Sengul
This study introduces a decision-oriented framework integrating fresh-state rheology, standardized post-cracking performance, and cradle-to-gate embodied carbon for steel-fiber-reinforced concretes incorporating recycled and commercial fibers. The motivation lies in achieving mechanical efficiency while reducing the environmental burden of cementitious composites. Mixtures were produced with water-to-binder ratios between 0.40 and 0.60, fiber dosages of 15–45 kg/m3, and 50% GGBS replacement to mitigate binder-related carbon emissions. Equal-workability comparisons were conducted at 15 kg/m3 using ICAR-based static yield stress measurements, whereas higher dosages were evaluated without rheology-based adjustment. Post-cracking performance was assessed through residual flexural strengths at CMOD = 0.5 and 2.5 mm (fR1, fR3) and CMOD-based toughness indices. Embodied performance was quantified using the embodied-carbon-per-performance (ECP) index, normalized by fR3. Results indicate that recycled fibers exhibit greater fresh-state resistance but slightly lower residual capacities under equal workability, while commercial fibers achieve competitive ECP at 15 kg/m3. Increasing fiber dosage improved toughness yet intensified the trade-off between ECP and mechanical gain. The framework highlights that optimized binder composition and fiber type selection can yield carbon-efficient, structurally resilient composite systems.

5 November 2026 in Applied Sciences
Verified
Journal Article
Open access
PDF file
CCCansu Colak
Cansu Colak
OSOzkan Sengul
Ozkan Sengul
Recycled steel fibers (RFs) recovered from end-of-life tires (ELTs) are a potential alternative to manufactured steel fibers in concrete, but their irregular geometry may limit their effectiveness. This study compared RF and commercial hooked-end steel fibers (CFs) in ordinary Portland cement concrete produced at water-to-cement ratios (w/c) of 0.40, 0.50, and 0.60 with fiber dosages of 15, 30, and 45 kg/m3. Workability, compressive strength, flexural strength, residual flexural strengths (fR1 and fR3), and toughness were determined, and a multi-response desirability approach combining compressive strength, fR3, and toughness was applied. Both fiber types improved the post-cracking response; however, CF provided higher residual strengths and toughness, whereas RF reduced workability more and showed a greater loss of residual capacity between fR1 and fR3. Compressive strength was governed mainly by w/c rather than fiber dosage. The highest overall desirability was obtained with 45 kg/m3 of CF and a w/c of 0.40, with a geometric mean (D) of 0.653, while for RF the maximum was obtained with 30 kg/m3 and w/c = 0.40 (D = 0.285). RF effectiveness depends on matrix quality and dosage, and RF should be selected according to the required post-cracking performance rather than as a direct replacement for CF.